Advertisement
2020/12/12 02:35:59 (GMT+09:00)
④Regardless of Good board or Defective board, always put it
on ESD cushion/sheet slowly.
⑤Do not stack up
⑥Keep vertical position and put in/take out from Box.
Always put in to ESD bag then place into Box/Container Box.
SAFETY NOTES
SELF DIAGNOSTIC FUNCTION
S E C T I O N 1
S A F E T Y N O T E S
TROUBLESHOOTING
SERVICE ADJUSTMENT
⑦Do not hold Heat-Sink when take out or install it..
2) Caution for Board handling(ESD)
Be sure to observe the following contents.
①When take off Rear-Cover,
do not touch to board
DIAGRAMS
PANEL HANDLING
②Use ESD wrist-strap
FACTORY DATA RESET
9
SYS SET
- Quick Links:
- Section 5 : Diagrams
Hide quick links:
Advertisement
