Cyber Power RCCARD100 Quick Start Manual

REMOTE CLOUD CARD REMOTE CLOUD CARD
RCCARD100 RCCARD100
Quick Start Guide
INSTALLATION GUIDE
Step 1. Hardware Installation
1. Remove the two retaining
screws from the expansion
slot, and remove the cover.
2. Install the Remote Cloud
Card into the expansion slot.
3. Insert and tighten the
retaining screws.
4. Connect an Ethernet cable to
the Ethernet port of the
Remote Cloud Card.
NOTE: The Remote Wireless Cloud Card is
hot-swappable, so you do not need to turn o the
device to install it.
QR Code
LINK Indicator
Copyright © 2021 Cyber Power Systems, Inc. All rights reserved.
R C
C A
R D
1 0 0
Li nk
T x/
R x
C y
b e rP
o w
e r
R C
C A
R D
1 0 0
T x/
R x
C y
b e rP
o w
e r
Ethernet Port
Cloud
Tx/Rx Indicator
1
Definitions for the LED Indicators
Link LED color
The Remote Cloud Card is not connected to the
O
Network/ or the Remote Cloud Card power is o .
On (Yellow)
The Remote Cloud Card is connected to the Network.
Tx/Rx LED color
O The Remote Cloud Card power is o .
On (Green) The Remote Cloud Card power is on.
- Receiving/transmitting data packet
Flashing
- Reset finished
Step 2. Application Installation
Install the "POWERPANEL" application available for download on
the Apple App Store or Google Play, then launch the application.
iOS
Step 3. Sign Up and Login, as shown in Figure 1
Step 4. Add a device in the POWERPANEL app
1. Click "+" in the upper right corner of the homepage, as shown in
Figure 2.
2. Locate the "Add Device by QR Code" to add your Remote Cloud Card.
3. Scan the QR Code on the Remote Cloud Card you are adding.
If the QR Code scan was successful, click "Add" and name the
device you are monitoring.
4. After the setup is completed, you will see your device on the
homepage, as shown in Figure 3.
Condition
Android
Figure 1
2
Figure 2
Figure 3
3