RCGF 40CC-Twin Operator's Manual page 6

3. Connect the kill switch lead to the red connector from the ignition control module using
the lead from the kill switch or with the included three pin connector with pig tail. Use one
of the included three pin securing clips to secure the connection.
4. Connect the ignition module battery to the kill switch. Any 4.8-8.4V, 1000mAh and
above capacity battery will work well for this. Use heat shrink tubing to secure this
connection.
5. Install the ignition kill switch and charge jack on the aircraft so that it is easily
accessible from the outside of the plane.
6. Install the ignition module securely in the airplane forward area. It is recommended
that a thin piece of foam rubber is placed between the module and the mounting surface
and that Velcro ® is used to hold the module in place.
7. Secure all connections with heat shrink tubing (not supplied)
8. Install the silicone ignition wire cover over the ignition wire to the spark plug.