Refrigerant recover / recycle / vacuum and recharge unit (13 pages)
Summary of Contents for CPS Tech-Set TR19 Series
Page 1
Tech-Set TR19 SERIES ® 2 Cylinder Commercial Refrigerant Recovery Machine OWNER’S MANUAL (English) Series: TR19, TR19S, TR19E TO BE OPERATED BY QUALIFIED PERSONNEL ONLY Evaluated for performance in accordance with Sec. 608 of the Clean Air Act (Feb 29, 1996) using AHRI-740-98 test methods.
GENERAL SAFETY INSTRUCTIONS Please read, follow and understand the contents of this entire manual, with special attention given to Danger, Warning and Caution statements. FOR USE BY PROFESSIONALLY TRAINED AND CERTIFIED OPERATORS ONLY. MOST STATES, COUNTRIES, ETC., MAY REQUIRE USER TO BE LICENSED. PLEASE CHECK WITH YOUR LOCAL GOVERNMENT AGENCY.
SPECIFICATIONS Model Number TR19 TR19S TR19E 115 V 220-240 V 220-240 V Voltage (Hz) 50 / 60 Hz 50 / 60 Hz 1PH 50 / 60 Hz 1PH Motor Size (Horsepower) 1/2 HP Motor Thermally Protected Compressor Type 2 Cylinder Oil-less Reciprocating Compressor Overload Protection Motor Thermally Protected Power Consumption...
DIRECT VAPOR OR LIQUID RECOVERY The following is recommended to maximize recovery rates; A. Use the shortest length of 3/8” ID refrigeration hose on the suction side of the unit. B. If the refrigerant is clean, remove all suction side filters, screens, etc... C.
HIGH SPEED DIRECT LIQUID RECOVERY The following is recommended to maximize recovery rates; A. Use the shortest length of 1/4” ID refrigeration hose on the suction side and discharge side of the unit. B. If the refrigerant is clean, remove all suction side filters, screens, etc... C.
PUSH-PULL LIQUID RECOVERY The following is recommended to maximize recovery rates; A. Use the shortest length of 3/8” ID refrigeration hose on the suction side of the unit to the vapor port on the tank. B. Use 3/8” ID refrigerant hoses from the system liquid service valve to the liquid port on the tank.
Figure 1. 2. Remove suction port-filter cartridge as shown in Figure 2. 3. Clean cartridge or replace with new cartridge. (CPS #CRXF3) 4. Inspect O-ring. Re-lubricate with compressor oil or equivalent. 5. Place filter cartridge back into suction port fitting.