Table of Contents
Advertisement
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option
for setting up password security. The password can be set through the On-Screen Display
(OSD) menu. For details of the OSD menu operation, please refer to
page
18.
You will be inconvenienced if you activate the password functionality and subsequently forget
the password. Print this user manual (if necessary) and write the password you used in this
manual, and keep it in a safe place for later use.
Setting a password
1.
Open the OSD menu and go to the SYSTEM SETTING: Advanced > Security
Settings menu. Press MODE/ENTER on the projector or remote control. The
Security Settings page is displayed.
2.
Highlight Change Password and press MODE/ENTER.
3.
As pictured to the right, the four arrow keys
( , ,
, ) respectively represent 4 digits (1,
2, 3, 4). According to the password you desire to
set, press the arrow keys to enter six digits for
the password.
4.
Confirm the new password by re-entering the
new password.
Once the password is set, the OSD menu returns to the Security Settings page.
5.
To activate the Power on Lock function, press
press
/
enter the correct password to turn on the projector.
6.
To leave the OSD menu, press MENU on the projector or MENU/EXIT on the
remote control.
•
Once a password has been set, the projector cannot be used unless the correct password
is entered every time the projector is started.
•
The digits being input will be displayed as asterisks on-screen. Write your selected
password down here in this user manual in advance or right after the password is entered
so that it is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this user manual in a safe place.
If you forget the password
If the password function is activated, you will be asked
to enter the six-digit password every time you turn on
the projector. If you enter the wrong password, the
password error message as pictured to the right is
displayed lasting for three seconds, and the message
'INPUT PASSWORD' follows. You can retry by
entering another six-digit password, or if you did not
record the password in this user manual, and you absolutely do not remember it, you can use
the password recall procedure. See
details.
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
to select On. When the Power on Lock function is activated, you have to
"Entering the password recall procedure" on page 20
19
"Using the menus" on
INPUT NEW PASSWORD
/
to highlight Power on Lock and
Password Error
Please try again.
MENU
Back
for
Advertisement
Table of Contents
