Advertisement
COMPATIBILITY
The UWL-400F is compatible with most cameras featuring a 24mm lens (or a higher focal range).
It can also be used with some cameras featuring a wider lens by zooming in to avoid a vignette.
The UWL-400F features a 52mm thread and can be mounted directly on 52mm threaded housing
lens ports or on lens ports featuring a different thread, by using a compatible adaptor.
For a selection of adaptors available, please visit our website -
INSTRUCTIONS FOR USE
1. Please use the utmost care and do not use excessive force when assembling and
disassembling the lens, in order not to cause any damage to the product.
2. Install the secure string on the lens:
a. Using the O-ring remover, remove the two rubber bands installed on the lens
barrel.
b. Wrap the Velcro secure strap around the lens barrel starting with the end
featuring the Velcro, having the Velcro facing out of the lens (Fig.1).
c. Continue until the strap is wrapped around itself and the Velcro attaches (Fig.2).
d. Install the secure string by inserting it through the lanyard loop on the Velcro
secure strap, then pulling it through itself and testing it in order to make sure it is
secure (Fig.3).
3. It is recommended to attach the secure string of the lens to the housing, in order to
secure it. If making use of an arm in the system, the secure string can be secured to the
arm rather than to the housing.
4. Unscrew the rear cap of the lens until it can be removed.
5. Prior to installing the lens on the housing, it is recommended to apply a small amount of
silicone grease on the threaded area of the lens (and adaptor, if used) in order to
prevent corrosion. Make sure that no grease is applied over the lens glass.
6. If using an adaptor, install it on the lens by screwing it all the way in.
4
Fig.1
UWL-400F Wide Angle Lens Instruction Manual 20190213
www.fantasea.com
Fig.2
Fig.3
Advertisement
