Subscribe to Our Youtube Channel
Summary of Contents for Micro-Pulse ICES C5
- Page 1 Use and Care of the ICES model C5 Bob Dennis Micro-Pulse LLC COPYRIGHT © 2018 Micro-Pulse LLC...
-
Page 2: Keep In Mind
Keep in mind All Micro-Pulse ICES products are: • NOT FDA APPROVED for any human medical condition • Sold as research instruments, without medical claims of any kind • Intended for RESPONSIBLE ADULT USE, for SELF-EXPERIMENT ONLY Also: • You should READ the C5 User Manual for details of operation •... - Page 3 Use any USB charger port: 2.1 Amp or greater Power cable MUST be USB-A on one end 3.5 mm barrel jack goes to the C5 USB Car charger ports: ALL USB charger ports deliver 5.0 Volts. COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 4 COIL CARE Getting the most out of Micro-Pulse Technology • ALWAYS check your coil function with the hexagonal coil tester • Do not pull on or yank or sharply or bend the coil cables • Make sure the coils are always firmly plugged in •...
-
Page 5: Flashing Red Led
• Check coils often, listen for clicks, and use the hexagonal coil tester • Don’t run on full power and maximum frequency for long periods • Do not cover the C5 with blankets or pillows (you can cover the coils, but not the device itself) COPYRIGHT © 2018 Micro-Pulse LLC... - Page 6 • The initial RUN screen looks like this if you -- A9 -- happen to have selected the A9 protocol - - - - - - ] 9 at intensity level = 9: -to reset: POWER OFF- COPYRIGHT © 2018 Micro-Pulse LLC...
-
Page 7: Advanced System Diagnostics
ADVANCED SYSTEM DIAGNOSTICS DO NOT WORRY ABOUT THESE SCREENS UNLESS THERE HAS BEEN A MAJOR MALFUNCTION. Call Micro-Pulse for troubleshooting • Once RUNNING, you can press the YELLOW Ch1 242/222V 91F (UP) button to view the internal voltages and Ch2 241/220V 89F temperatures as shown to the left. - Page 8 ADVANCED SYSTEM DIAGNOSTICS DO NOT WORRY ABOUT THESE SCREENS UNLESS THERE HAS BEEN A MAJOR MALFUNCTION. Call Micro-Pulse for troubleshooting • Once RUNNING, press the BLUE (DOWN) button to view the Channel 1 status of the coils. Four possible status indicators are shown: “OK”...
- Page 9 OFF. Check the coils: be sure they are plugged in all the way. A slightly pulled out coil may cause a short. • The system may automatically adjust your intensity (power level) down to a safe level, usually level 9. COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 10 POWER makes PEMF work better. When properly designed, PEMF works best at very low power. • If the C5 tells you it is in the danger zone, then it is too much. Tone it down a bit by reducing the power level. COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 11 Use any USB charger port: 2.1 Amp or greater Power cable MUST be USB-A on one end 3.5 mm barrel jack goes to the C5 USB Car charger ports: ALL USB charger ports deliver 5.0 Volts. COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 12 COIL CARE Getting the most out of Micro-Pulse Technology • ALWAYS check your coil function with the hexagonal coil tester • Do not pull on or yank or sharply or bend the coil cables • Make sure the coils are always firmly plugged in •...
- Page 13 • Do not run at full power and maximum frequency • Do not cover with pillows or blankets • Use in a cool location with air flow • Make sure all coils are firmly plugged in COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 14 OK to place coils under pillows/blankets Coils and coil arrays CAN be placed under pillows and blankets • Make sure coils are firmly plugged in • Test coils frequently using hexagonal coil tester COPYRIGHT © 2018 Micro-Pulse LLC...
- Page 15 Micro-Pulse Model C5 Bob Dennis COPYRIGHT © 2018 Micro-Pulse LLC...
Need help?
Do you have a question about the ICES C5 and is the answer not in the manual?
Questions and answers