FCC T11 User Manual

Walkie-talkie
T11 User Manual
This set includes 2 walkie-talkie units: these are
communication devices that operate on mobile radio
frequencies. They have 8(Europe)/ 22(US) channels as well
as a back-lit LCD screen, enabling you to communicate over
several kilometers free-of-charge (up to 3miles in open areas).
Note: Please read the instructions carefully before using the
equipment and retain for future reference.
Specific Recommendations
To avoid the risk of burns, do not use the device if the aerial
is damaged in any way.
Don not use the device in a potentially explosive setting
(e.g. Around pumps, on the lower deck of a boat or around
a fuel-storage installation or chemical products).
If traveling in a car or by bike, stop before using the device.
Switch off the device if on an airplane or in a hospital.
Never use the device in close proximity to a radio to avoid
interference.
Remove the batteries if the device is not used for an
extended period of time. Never mix used batteries with new
ones.
Keep the transmitter and antenna at least 5cm from your
face. Direct the antenna upwards and speak normally.
Clean the device with a damp cloth. Avoid the use of
cleaning agents and solvents.
Do not modify the device in any way. In the event of
damage occurring, ensure that the device is checked by a
qualified professional.
The device cannot be used to contact emergency services.
Functions at Glance
BEFORE USE
Removing the belt clip
Before insert batteries into the device, first pull the belt clip
latch away from the device.
Installing the Batteries
1. Slid down the battery compartment cover.
2. Insert 3 x AAA Alkaline Battery (Not included)
3. Position the batteries according to the polarity marking on
the battery compartment.
4. After placing batteries into correct positions, put the battery
cover back on.
Using the device
1. Turning the device on/off
Switch on the device: Press and hold on the
[ /MENU]button 3 seconds then you will hear a beep sound.
Switch off the device: Press and hold on the
[ /MENU]button 3 seconds then you will hear a beep sound.
2. Adjusting the volume
To increase the volume, press the Up[ ]button. And
press the Down[ ]button to decrease the volume.