Table of Contents
Advertisement
V-024U User Guide v2.qxd:V-024U User Guide
www.vax.co.uk
Replace floating brushbar (Fig 5/4).
Fig.5/4
Replace the brush access cover by inserting the end
furthest from the brush first. Then replace the front end
before securing in place with the two screws (Fig 5/5).
Fig.5/5
8
maintenance/ troubleshooting
12/3/08
All manuals and user guides at all-guides.com
08:47
Page 8
6. Troubleshooting
WARNING: To reduce the risk of personal injury,
!
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: The cleaner won't run.
Cause:
Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause:
No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause:
ON/off switch not turned on.
Solution: Push on/off switch to 'on' .
Cause:
Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
PROBLEM: Cleaner won't pick up/loss of suction.
Cause:
Dirty water tank is full.
Solution:
Switch off and unplug cleaner. Empty dirty
water tank as shown in Section 4.
Cause:
Dirty water tank not installed correctly.
Solution:
Refer to page 9 for fitting information.
Cause:
Obstruction in hose/nozzle.
Solution:
Remove hose and clear obstruction.
Cause:
Broken or worn belt.
Solution:
Replace the belt. See page 10.
Cause:
Brushbar is worn.
Solution:
Replace the brush bar. See page 10.
PROBLEM: Liquid escaping from the carpet washer.
Cause:
Dirty water tank is full.
Solution:
Switch off and unplug cleaner. Empty dirty
water tank as shown in Section 4.
Cause:
Dirty water tank not installed correctly.
Solution:
Refer to page 9 for fitting information.
Cause:
Solution tank not installed correctly.
Solution:
Make sure the tank is securely locked in place
PROBLEM: Clean solution won't dispense.
Cause:
Solution tank not installed correctly.
Solution:
Make sure the tank is securely locked in place.
Cause:
Solution tank empty.
Solution:
Refill tank. Refer to page 6 for instructions.
Advertisement
Table of Contents
