TTI WeedControl 12VSPT- Instructions For Assembly, Operation, Servicing & Storage

12v spot sprayer

Advertisement

Quick Links

WeedControl
12v Spot Sprayers
Instructions for Assembly, Operation, Servicing & Storage
Part No: 12VSPT-TTI
w w w . t t i . c o m . a u

Advertisement

Table of Contents
loading

Summary of Contents for TTI WeedControl 12VSPT-TTI

  • Page 1 WeedControl 12v Spot Sprayers ™ Instructions for Assembly, Operation, Servicing & Storage Part No: 12VSPT-TTI w w w . t t i . c o m . a u...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS INTRODUCTION Introduction Congratulations on the purchase of your 12 Volt Spot Sprayer. This sprayer has been manufactured to provide years of dependable and efficient use in Warranty spraying a wide range agricultural pesticides, herbicides and other non- Tools Required flammable liquids.
  • Page 3: Tools Required

    TOOLS REQUIRED 12V PUMP ASSEMBLY COMPONENTS Pre s su re Reg ulator P ress ure Gaug e (1 ) 1 /2” Snapp er Ho se As se m b ly ( 1 ) 33 - 11 24DA B 10 0...
  • Page 4: Spot Sprayer Assembly

    SPOT SPRAYER ASSEMBLY customercare@tti.com.au www.tti.com.au PARTS PARTS Creates Drain Cap Applies Drain Cap to Assembly Drain Port P re s s t h e D ra i n C a p G a s ket i nt o t h e D ra i n C a p u nt i l f u l l y s e at e d .
  • Page 5: Spot Sprayer Assembly

    SPOT SPRAYER ASSEMBLY customercare@tti.com.au www.tti.com.au customercare@tti.com.au www.tti.com.au PARTS PARTS NOTE: If you have a complete broadcast sprayer, skip this step and move on to step 7-9. Attaches Gun Clips to Attaches Gun Assembly Sprayer Tank to Sprayer Lo c at e t wo s c rew h o l e s o n f ro nt of S p raye r Ta n k .
  • Page 6: Operation - Important Safety Information

    SPOT SPRAYER ASSEMBLY customercare@tti.com.au www.tti.com.au PARTS PARTS NOTE: NOTE: Make sure Pressure Gauge is well Connecting wire harness seated, being careful not to over clamps to opposite posts tighten. will cause the Pump to run backwards. Make sure Pressure Gauge’s front is facing forward with Pressure Regulator knob.
  • Page 7: Before Spraying

    BEFORE SPRAYING AFTER SPRAYING Sprayer Prep: ALWAYS inspect and prepare the sprayer before use according to the Clean Sprayer: ALWAYS clean the sprayer immediately after use according to the directions provided in this manual directions provided in this manual...
  • Page 8: Praparing Spraying

    PRAPARING SPRAYING SPOT SPRAYER (CONTINUED) Review Safety Information: Review safety information in this manual and Spot Spraying: To spot spray, pull the gun trigger. Make sure nozzle of gun is manufacturer chemical label before use pointed towards vegetation in need of spraying...
  • Page 9: Operation

    OPERATION SPRAYER STORAGE CLEANING, DECONTAMINATING & STORAGE Prepare the sprayer for end-of-season storage by running RV anti-freeze through the system. This will keep internal parts lubricated, protect against When done using the sprayer, it is always important to clean the sprayer and corrosion, and keep the unit from freezing.
  • Page 10: Troubleshooting

    TROUBLESHOOTING Here you will find troubleshooting steps for some of the most common Problem Cause Solution issues users have with sprayers. Bad Electrical Connection Check Battery Connections Fuse Blown Replace Fuse Short In Wire Check Condition of Wires...
  • Page 11: Deluxe Spot Sprayer

    Part Number Description 15/25/40/60 Gallon Tank 33-103221 Tank Lid 33-103218 Drain Cap 33-103220 Drain Cap Gasket 33-103219 Drain Cap Tether 33-103222 Tank Lid Tether EF1000, EF2200-QA or 1.0, 2.2 or 3.0 GPM Everflo Pumps EF3000-QA EF-QC-A38 Hose Barb Fitting - QA x 3/8”...
  • Page 12 PLEASE FOLLOW ALL WARNINGS IN THIS MANUAL, FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE & INJURY w w w . t t i . c o m . a u...

Table of Contents