Installation Instructions; Install The Damper Stop; Install The Burner/Pan Assembly; Install The Grate - Hearth and Home Technologies outdoor lifestyles OD-18NG Installation Instructions Manual

Outdoor hearth kits
Table of Contents

Advertisement

4 4

Installation Instructions

A. Install the Damper Stop
Open the damper to the fully open position and secure it
open with the stop as shown in Figure 4.1.
If the damper stop doesn't fit your application, use a
permanent means that will keep the damper open at
least to the minimum vent opening as outlined in Table 1,
Section 1.B.
B. Install the Burner/Pan Assembly
The burner/pan assembly is shipped ready for right-hand
gas connection. See Section 3.B. for left-hand connection.
Remove the existing cap or gas jet assembly from the
gas stub in your fireplace. Clean the threads using a wire
brush or steel wool. Apply Teflon tape or pipe dope to the
steel fitting and attach the provided brass adapter to the
stub.
Place the burner/pan assembly in the fireplace. The pan
should be centered both front to back and side to side.
Bend the provided gas connector to facilitate its installation
between the burner and the gas stub.
Attach one end of the gas connector to the brass elbow
or safety pilot fitting. Attach the other end to the brass
adapter at the gas tube.
C. Install the Grate
The grate should be centered over the burner pan, side
to side. If the grate sits toward the front of the burner pan,
the flames will be larger coming through the logs. If the
grate sits toward the back of the burner pan, the ember
bed will be more prominent. Refer to Figure 4.2.
• Outdoor Lifestyles by Hearth & Home technologies Burner/Hearth Kits • 4004-316 Rev I • 01/2022
Figure 4.2
Center Stainless Grate Over Stainless Burner Pan
D. Place Lava Rock
Pour the lava rock into the burner pan. Lava rock should
follow the slope of pan, covering it and the burner tube
completely.
Allow the lava rock to spill out the front of the pan and over
the sides onto the fireplace floor.
The gas burns at the point of the least resistance. In
case of an uneven flame pattern it may be necessary to
adjust the materials in the pans (using an object such as
a screwdriver) to achieve the desired effect.
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Outdoor lifestyles od-24ng

Table of Contents