Advertisement
As long as the green Charcoal Filter
Light is on, the machine monitors
time and the number of brewings.
The green charcoal filter light will
start blinking either after 8 weeks or
after the Coffee Brewing Button has
been turned on 60 times whichever
comes first, reminding you to replace
the cartridge:
If you make coffee once a day, the
filter light will start flashing after 8
weeks. If you make coffee twice a
day, the light will flash after 30 days.
This will help you to plan the right
amount of cartridges.
Attention: When you unplug the
machine for more than 10 seconds or
if you have a power failure, the
electronic indicator loses its memory.
Then it is best to replace the filter 8
weeks after first use.
Caution: Once the cartridge is activated
you should never use it for longer
than six weeks. Harmful bacteria
build-up may occur. Unused
cartridges can be stored indefinitely.
Replacement cartridges are available
through your local Capresso dealer or
our website: www.capresso.com.
3b. Replacing the Cartridge /
Resetting the Filter Indicator
Remove the cartridge from the water
tank (Fig. 3), twist and open the holder
and discard the old cartridge. Replace
with new cartridge (Fig. 4) and close
the filter holder securely.
Insert the assembly back into the
water tank (Fig. 3) and make sure it is
inserted properly.
Activate the charcoal filter (chapter 3a).
While the green light is still blinking,
push and hold the Charcoal Filter
Button for a few seconds until the
light stops blinking and is illuminated
again. Now the indicator starts counting
again.
4. The Proper Sequence for Making
Coffee
Coffee makers produce very hot
water. If you follow the sequence as
described below you will avoid possible
accidents which might cause severe
injuries and burns.
1. Remove the water tank (Fig. 9) and
fill with the desired amount of
water. Replace the water tank and
make sure it sits firmly in place.
Caution: Make sure the water
level does not exceed the MAX
setting (Fig. 6). If you fill too much
water into the tank the carafe may
overflow with hot coffee.
2. Open the filter basket lid (Fig. 1, A).
Make sure the filter holder insert sits
firmly in place with the handle
pushed down. If the filter holder is
not snapped into the housing, the
drip stop in the filter holder might
not open during brewing and hot
water and grinds could overflow
and leak from the machine.
3. Insert the GoldTone Filter (chapter
5a) or filter paper (chapter 5b).
4. Add the correct amount of ground
coffee (chapter 5c).
5. Close the filter basket lid.
6. Make sure the thermal carafe is
empty and the lid of the thermal
carafe is completely closed (Fig. 11).
Insert the carafe into the machine.
7. Turn the machine on (Fig. 2, L).
8. Never open the filter basket lid
(Fig. 1, A) as long as coffee is
brewing. Hot water could spill out
causing burns. Wait until the
brewing noise stops.
9. Immediately after brewing is finished
there could still be hot water in
the filter holder passing through
the ground coffee. This can take
1 to 3 minutes depending on how
much coffee you used and how
fine the coffee was ground.
8.
Advertisement
