Table of Contents
Advertisement
• To prevent the waste water to go back into the product again and to ensure easy drainage, do not immerse
the end of the hose into the waste water or do not insert it into the drain for more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched
between the drain and the product.
• If the length of the hose is too short, use it by adding an original extension hose. Length of the hose may
not be longer than 3.2 m. To avoid water leak failures, the connection between the extension hose and the
drain hose of the product must be fitted well with an appropriate clamp as not to come off and leak.
4.1.6 Adjusting the feet
A
WARNING:
balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its place and cause
crushing, noise and vibration problems.
WARNING:
1
Loosen the lock nuts on the feet by hand.
2
Adjust the feet until the product stands level and balanced.
3
Tighten all lock nuts again by hand.
4.1.7 Electrical connection
Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any
damages that may arise when the product is used without grounding in accordance with the local regulations.
• Connection must comply with national regulations.
• The electrical connection cable infrastructure of the product must be adequate and suitable for product
requirements. It is recommended to use a residual current device.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
• The voltage specified in the "4. Technical specifications" section must be equal to your mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
WARNING:
Electrical requirements
Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the
rating label corresponds to your electricity supply.
We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket
in a readily accessible position.
Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced
by a special purpose made mains lead which can only be obtained from an Authorised Service Agent.
B
WARNING:
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate
plug fitted.
Destroy the old plug, a cut off plug with a bare cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
10 / EN
In order to ensure that the product operates more silently and vibration-free, it must stand level and
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
Damaged power cables must be replaced by the Authorised Service Agent.
This appliance must be earthed
Washing Machine / User's Manual
Advertisement
Table of Contents
