Table of Contents
Advertisement
Operations
Manual Dry
You can change the drying settings manually to your preference.
QUICK DRY
TIME DRY
AIR FLUFF
WRINKLE RELEASE
Steam Cycles (DVE(G)50R5400* models only)
Use steam to reduce wrinkling and odors on items.
Cycle
STEAM SANITIZE
REFRESH
WRINKLE AWAY
46
English
Untitled-3 46
A quick drying cycle running for 30 minutes.
The default cycle time is 30 minutes. However, you may
manually change the cycle time if necessary.
You can specify a cycle time in minutes.
If TIME DRY is selected, the Eco Dry function is enabled by
default. For more information, see Eco Dry in the "Control panel"
section.
Tumbles the load in room temperature air.
The WRINKLE RELEASE cycle will release wrinkles from items
that are clean, dry, and only slightly wrinkled, such as clothes
from a crowded closet, suitcase or items that have been in the
dryer too long after the cycle has ended. WRINKLE RELEASE can
be used with any temperature selection.
Use to sanitize items by applying steam and high-temperature
heat to the fabric. This cycle can make items soft and reduce
smells. Confirm that the laundry load is wet or partially wet
before starting this cycle.
Use to smooth out wrinkles and reduce odors in loads of one to
four items. With this cycle selected, a small amount of water is
sprayed into the dryer drum after several minutes of tumbling
with heat. Confirm that the laundry load is dry.
For best results, load 2-3 items at once. You can extend the
drying time by a minimum of 20 minutes, depending on the
item type or load. Confirm that the laundry load is dry.
Description
2021-02-02
3:23:27
Advertisement
Table of Contents
