Table of Contents
Advertisement
Removing Procedure
A phillips-head screwdriver or a flathead screwdriver is required to remove a unit from a DIN rail.
CAUTION
Disconnect LAN cables and power cables connected to the unit before removing from the DIN rail.
For a Phillips-head screwdriver
(1) Insert a phillips-head screwdriver (diameter: 6 to 7mm) into the latch metal fitting on the lower part
of the unit. Do not use excessive force. Doing so may damage the DIN rail mounting bracket or the
unit.
Figure 3.2. Removing a unit from a DIN rail with a phillips-head screwdriver < 1 / 3 >
(2) The latch metal fitting is pushed down and the unit is ready to be removed from the DIN rail.
Figure 3.2. Removing a unit from a DIN rail with a phillips-head screwdriver < 2 / 3 >
3. Setup of Hardware
12
Advertisement
Table of Contents
