Advertisement
Quick Links
Advertisement
Summary of Contents for Evolution BodyLift
- Page 1 EVOLUTION HEALTH AND FITNESS BodyLift Assembly Instructions...
- Page 2 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 1 Make sure you have all the pieces needed for assembly. There should be two cushioned pieces for the seat, two legs, one support bar that will attach to the legs, four bolts, and four flat washers.
- Page 3 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 2 The the top of the cushions face down on the floor and the bottom with the instructions facing you take one leg and hold it against the cushion. The angle of the bend should roughly align with the diagram of the leg on the instruction sheet adhered to the cushion.
- Page 4 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 3 While continuing to hold the leg in place place one of the flat metal washers on top of the hole nearest you in the leg.
- Page 5 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 4 While continuing to hold the leg in place insert one of the bolts through the washer and into the hole. Turn the bolt clockwise with your fingers and tighten (do not use the wrench to tighten yet). This should be sufficient to hold the leg in place temporarily.
- Page 6 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 5 Repeat with the other leg. Hold the leg in place, place a metal washer on top the hole, put bolt through hole, and turn clockwise until finger tight.
- Page 7 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 6 Both legs should now stay in place without holding onto them.
- Page 8 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 7 Place the metal support bar across the legs, aligning the holes in the support bar with the holes in the legs of the BodyLift with the holes in the cushioned seat.
- Page 9 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 8 Place the remaining flat metal washers on top of the metal support bar, one atop each hole.
- Page 10 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 9 Insert a bolt through the washer and turn counter clockwise making sure it is screwing into the hole in the seat cushion. Do this for both sides of the support bar.
- Page 11 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 10 With all four bolts in place, tighten all four bolts with the wrench, be careful to not over tighten them. It should take roughly a half turn (90 degrees) of the wrench (depending on how tight you did it by hand.
- Page 12 ’ VOLUTION EALTH SSEMBLY NSTRUCTIONS Step 11 Flip the BodyLift back over to sit on its legs, it is ready to use!
Need help?
Do you have a question about the BodyLift and is the answer not in the manual?
Questions and answers