SOMFY Irismo Installation Manual
SOMFY Irismo Installation Manual

SOMFY Irismo Installation Manual

Advertisement

Tools Required:

• Torx T-9 Bit (For original motor screws)
• Torx T-10 Bit (For replacement screws)

Kit Includes:

• ABS Plastic Enclosure (Top and Bottom Halves)
• Snap-Together Velcro
• (2) M3 x 25 T-10 Torx Screws

Installation:

1. Using a T-9 screwdriver, remove the (2) Torx screws near the modular jack as
shown below:
Irismo Enclosure Installation
Somfy P/N - 9021132
Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Irismo and is the answer not in the manual?

Questions and answers

Summary of Contents for SOMFY Irismo

  • Page 1 • ABS Plastic Enclosure (Top and Bottom Halves) • Snap-Together Velcro • (2) M3 x 25 T-10 Torx Screws Installation: 1. Using a T-9 screwdriver, remove the (2) Torx screws near the modular jack as shown below: Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved...
  • Page 2 2. Take the bottom half of the enclosure and using a T-10 screwdriver, fasten to Irismo via (2) M3 x 25 screws until snug. 3. Take Snap-Together Velcro and stick one side to the raised rectangle. Press and hold Velcro for a few seconds to ensure good adhesion.
  • Page 3 4. The Irismo Enclosure is designed to house 3 different interface cards: • SDN (P/N: 1811129) Zigbee (P/N: 1870221) & Z-Wave (P/N: 1870228) 4a. SDN Card Installation • Insert the RJ-12 plug into the motor and remove the Velcro adhesive backing.
  • Page 4 • Insert the RJ-12 plug into the motor and remove the Velcro adhesive backing: Remove adhesive backing • Center card inside enclosure as shown below: IMPORTANT Don’t go past this edge! Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved...
  • Page 5 4c. Z-Wave Card • Insert the RJ-12 plug into the motor and remove the adhesive backing: Remove adhesive backing • Center card inside enclosure as shown below: IMPORTANT Don’t go past this edge! Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved...
  • Page 6 5. Attach the top by squeezing and aligning the hooks with the slots: Squeeze here Installation is complete! Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved...

This manual is also suitable for:

9021132

Table of Contents