Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
DRY IRONING
1.
Plug into the power supply.
2.
Turn the steam control knob to "
3.
Turn the temperature control in a clockwise direction; select ● (1 dot), ●● (2 dots) or ●● ● (3
dots) according to the recommendation of the garment label.
4.
Indicator light will light up, then put the iron on a smooth and stable surface vertically.
5.
When the required temperature is reached; indicator light goes off. The iron is ready for use.
SPRAY FUNCTION
1.
This function can be used any time and it does not affect the ironing temperature.
2.
Make sure there is enough water in the water tank.
3.
Aim the nozzle toward the garment.
4.
Press the spray button a couple of times to moisten the garment.
STEAM FUNCTION
1.
Make sure there is enough water in the water tank.
2.
Plug into the power supply.
3.
Turn the temperature control in a clockwise direction to " ● ● ● "(3 dots) or " ● ● "(2 dots) setting.
(Do not use 1 dot setting for steam ironing). Indicator light will light up indicating the iron is switched
on.
4.
After the indicator light switches off, which indicate that the selected temperature has been reached.
5.
Turn the steam control knob to the required position. Steam will be sprayed and you can start
ironing.
6.
During breaks in ironing, stand the iron upright.
7.
When you are finished ironing, pull out the plug from the power supply and allow to cool. Turn the
iron upside down and allow the water to drain out.
CAUTION: Avoid coming in contact with ejected steam.
BURSTS OF STEAM FUNCTION
1.
This function provides an extra amount of steam to remove stubborn wrinkles.
2.
Fill the water tank with water.
3.
Plug into the power supply.
4.
Set the temperature control at the " ● ● ● "(3 dots) position, otherwise, water may leak from the
soleplate if the temperature is low. Indicator light will illuminate to indicate that the iron is switched
on.
5.
Indicator light switches off when the required temperature is reached.
6.
Press the Bursts of Steam button once.
7.
It may be necessary to press the Bursts of Steam button a few times to start function.
8.
Steam will penetrate into the garment removing the wrinkles.
9.
Wait for a few seconds before pressing the Bursts of Steam button again when there are stubborn
wrinkles.
10. For optimum steam quality, do not use the Bursts of Steam more than three times after the indicator
light goes off.
" position.
5
Advertisement
Table of Contents
