Table of Contents
Advertisement
FROTHING MILK/PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate,
water or tea.
Method:
1. Remove the removable tank and fill it with desired water, the water level should not
exceed the "MAX" mark in the tank, insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press down the ON/OFF button "
to turn on the unit, the power indicator light (red)
"
illuminates.
4. Press down the pump control button "
to the lower position, make sure the
"
coffee/steam button "
is at the higher position, the pump will pump water, when there is
"
water flowing out, close the pump immediately.
5. Press down the coffee/steam button"
to the lower position and wait for a moment, the
"
appliance begins to heat until the (yellow) lamp illuminates, it means the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam
wand about 2 centimeters into the milk. Turn the steam knob in anti-clockwise slowly to start
making steam.
7. When the desired result is achieved, you can turn the steam knob to the "O" position.
8. Please follow this operation to prevent steam outlet being blocked after milk frothing is
done: put an empty jug under the steam band, then turn on the steam knob and press down
the pump control button "
" to the lower position, the pump will pump water, after the
water flows for 30 seconds, press the pump control button "
" to the higher position, finally,
clean the steam outlet with wet sponge, take care not to get scalded!
9. Press and release the ON/OFF button "
to cut off the power source.
"
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the
steam knob to "O" position and make the coffee maker cool down for about half an hour,
then poke the steam outlet a few times with a needle about 1mm in diameter, finally, press
down the coffee/steam button " " and turn on the steam knob to check if the appliance can
produce steam normally when the steam indicator (yellow) illuminates. Please contact
Pensonic Customer Care Centre if the appliance is unable to produce steam after operating as
above.
Advertisement
Table of Contents
