Advertisement
Operator should ALWAYS
•
Be familiar with operating controls, pro-
cedures, and warnings.
•
Make sure that all connections to load
are tight and secure.
•
Make sure to know the content of the op-
erational instructions.
•
Make sure that load is free to move and
that no obstructions may hinder/prevent
the lifting.
•
After a few centimetres, check the load
for balance before continuing.
•
Avoid that the load swings.
•
Make sure that all persons stay clear of
the suspended load.
•
Warn persons before lifting the load.
•
Protect load chain from weld spatter or
other damaging contaminants.
•
Promptly report to your supervisor or
workshop in case anything unforeseen
happens or a component is damaged.
•
Regularly inspect beam, replace dam-
aged or worn parts, and keep appropriate
records of maintenance.
Important Note:
Reproduction and any commercial use (of parts) of this operating manual, requires a written permission
of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Operator should
•
Never lift more than rated load.
•
Never us damaged component or com-
ponent that is not working correctly.
•
Never us the beam with twisted, kinked,
damaged, or worn chain.
•
Never lift a load if any obstruction inter-
feres with lifting.
•
Never allow attention to be diverted from
operating the device.
•
Never use beam to lift, support, or
transport people.
•
NEVER LIFT LOADS OVER PERSONS'
HEADS!
•
Never leave a suspended load unat-
tended.
•
Never allow contact between device and
other objects.
•
Never allow the chain or link to be used
as a welding surface.
•
Never allow the chain or link to be
touched by a live welding electrode.
•
Never attempt to lengthen the load chain
or repair damaged chain.
Item 50798
Page 5
09
2021-1
Advertisement
