lifelong POWER PRO User Manual page 4

WET/DRY GRINDING
STEP 1: The wet /dry grinding jar (refer fig 2) is used
for grinding items like ldli and dosa batter, coconut
chutney, groundnut, red chili powder, sugar, palak etc.
STEP 2: Make sure that the dry grinding jar is
absolutely clean and dry before use.
STEP 3: Use small pieces of ingredients for grinding.
Fill the jar with ingredients up to the marked
STEP 4:
capacity
STEP 5: Put the flat lid on top of the Jar. Grind at low
speed for 15-30 seconds and then move to higher speed
Note:
Always move gradually from lower speeds to higher speed. During grinding
process, the jar might gethealed up due to friction. Do not panic. This happens
gradually.
CHUTNEY MAKING
STEP 1: The chutney jar (refer fig 3) is mainly used for
making chutney.
STEP 2: Use small pieces of ingredients for grinding.
Step 3: Put the ingredients in the chutney jar for
grinding. Hold the lid tightly so that it won't get healed up.
STEP 4: The ingredients should not be too large. Break
ingredients into smaller pieces.
Note:
The lid should be properly pressed.
OVERLOAD PROTECTION
• The overload protector (OLP) is designed to protect the
motor (refer fig 4) from burning.
• In case of an overload, the blade of the jar stops rotating and
the motor gets jammed or starts heating up.
• If such a situation occurs the mixer grinder will automatically
trip off and hence protect the motor.
• Let the motor cool down for a couple of minute. The red
button of the overload protector switch located at the bottom
of the mixer grinder has to be pressed for re-operation.
• If you have to reset the OLP again and again, try reducing
the quantity of ingredients in the Jar
CLEANING INSTRUCTIONS
• Before use pour warm water in the jar, run for a few seconds and throw
away the water.
• The cleaning of the mixer grinder and jars are very necessary for maintaining
smooth operation of the mixer grinder and proper hygiene.
• After you have used the mixer grinder, use warm water to remove the smell
of the material from the jars and then rinse under running water.
• In order to clean the blades thoroughly, remove the blades by using the
spatula to loosen the screw by twisting the dome nut on the blade clockwise,
while holding the coupler from under the jar.
overload protector