Advertisement
WIRING FOR OUTPUT
Reference 3004A 4-channel output (4ohm/2ohm)
Reference 3004A 3-channel output (Font:
4ohm/2ohm;
Rear:4ohm)
Reference 3004A 2-channel output (4ohm)
Reference 7005A
5-channel output (4ohm/2ohm)
CONNECTING THE REMOTE BASS
CONTROLLER (REFERENCE 7005A ONLY)
8
o
t,
.
.
.
1
REMOTE
CONTROL
1
SETTING GAIN, CROSSOVERS, AND BASS
BOOST
~
HPF
X-OVER
AJU
LPF
~m320H•
FREQ
32Hz
Setting the gain
1. Start with
GAIN
control set to minimum,
and the crossover control rotated midway.
2. For the front and rear channels, choose
music you're familiar with. For the
subwoofer channel on the Reference
7005A, choose music with substantial bass
content.
3. Turn the volume control on your receiver to
¾
of its total output.
4. Adjust the
GAIN
control clockwise,
listening carefully to the bass output. If
you hear distortion, turn the
GAIN
control
counterclockwise to decrease the gain.
Selecting the crossover mode
On the front and rear channels, you can select
your preferred crossover mode.
Choose
HPF
to allow only frequencies
above a certain point to reach your speakers.
Recommended if you're using a subwoofer in
your system, as it keeps low base from your
full-range speakers.
Choose LPF
to allow only frequencies below
a certain point to reach your speakers.
Recommended if you're bridging the front or
rear channels to power a subwoofer.
Choose FULL
to allow all frequencies to reach
your speakers. Recommended if you're not
using a subwoofer in your system.
Note:
The crossover mode for the subwoofer
channel of the Reference 7005A is low-pass
only.
Selecting the crossover frequency
Choose the crossover point to suit listening
preferences. Turn the dials to the left to lower
the crossover point and to the right to raise
the crossover point. Exact crossover settings
for coaxial speakers and subwoofers depend
on your listening preferences.
Advertisement
