FeinTech VAX01202 Instruction Manual page 13

eARC / ARC operating mode
Make sure that the HDMI eARC or ARC connector on the television is
connected to the eARC/ARC OUT 1 of the VAX01202. Connect Audio
Out 2 to an HDMI input of your sound system. Set the dip switch (3)
to the eARC ON position. You may also need to switch the audio out-
put on the television to HDMI ARC. The sound from the TV set (from
apps, the TV reception unit and connected HDMI devices) is now
output at audio output OUT 2. The internal TV speakers usually switch
off. If the TV set is equipped with eARC, all audio formats can be
transmitted. If the TV set has ARC, audio formats up to a maximum
of Dolby Digital Plus can be output. On some TV sets, only stereo or
Dolby Digital 5.1 is possible.
HDMI pass/audio splitter Operating mode
Connect an HDMI input on your TV to eARC/ARC OUT 1 on the
VAX01202 and Audio Out 2 to an HDMI input on your sound system.
Connect an HDMI source to the INPUT (4) input. Set the dip switch
(3) to the eARC OFF position. The television receives the looped-
through signal from the HDMI source. In addition, the sound with
black picture is output at audio output OUT 2. You can influence the
negotiation of the supported audio formats with the Dip switch. As a
rule, the setting OUT2 is useful so that all audio formats of the sound
system are supported. The TV set may then remain silent.
Safety instructions and recycling
• Please do not cover the housing or power supply unit and do not
install the unit to avoid overheating.
• Keep away from heat sources, fire, water and moisture.
• Do not place any heavy objects on the unit or the connecting
cables.
13