Main Menu
Table Of Contents
Automatic Transmission Fluid
DIPSTICK
Check the fluid level with the engine
at normal operating temperature.
1.
Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing step 2.
HOT
MARK
2.
Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.
3.
Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
2008 Fit
Transmission Fluid
4.
Remove the dipstick, and check
the fluid level. It should be
between the upper and lower
marks.
5.
If the level is below the lower
UPPER
mark, add fluid into the dipstick
MARK
hole to bring it to the level
LOWER
between the upper and lower
MARK
marks.
Pour the fluid slowly and carefully so
you do not spill any. Clean up any
spill immediately; it could damage
components in the engine
compartment.
Always use Honda ATF-Z1
(automatic transmission fluid).
CONTINUED
193