Page 1: Table Of Contents
Installation Guide IOIO Box for use with SmartMove Go tablet version Version 2.0 – May 2021 STEP SUMMARY PAGE Overview Equipment Checklist Wiring Diagram Installation Bluetooth Setup Wired Setup Tablet Setup Troubleshooting...
Page 2: Overview
 Receive a signal from the physical duress alarm and trigger the panic functionality in SmartMove (e.g. make a silent call to the base so the base can hear what is going on inside the car).  Charge the tablet (USB cable used for data/power).
Page 3: Equipment Checklist
SmartMove Installation Guide Equipment Checklist The IOIO Box requires the following parts, some supplied by SmartMove. Components: 1 x IOIO Box (SmartMove supplied) 1x Panic Switch (SmartMove supplied) If previous equipment is installed, it is possible to wire the old button to the IOIO.
Page 4 1 x ~25mm diameter Heatshrink (Optional) 1x Serial-RJ45 adaptor + RJ12 cable (Optional) (SmartMove supplied if required) For use with the CabCharge EFTPOS machine. Version: 2.0 – May 2021 Page 4...
Page 5: Wiring Diagram
SmartMove Installation Guide Wiring Diagram Version: 2.0 – May 2021 Page 5...
Page 6: Installation
Notes: If your dome light is controlled by the Meter, then wiring it into the IOIO Box (4) is optional. The benefit of wiring the dome light is to allow control from the built in soft meter. Powering the meter with the IOIO Box (3) is also optional. The benefit of powering the meter directly allows the meter to be powered on only when logged into SmartMove.
Page 7: Bluetooth Setup
SmartMove Installation Guide Bluetooth Setup Plug the Bluetooth adaptor into the USB out of the IOIO Box. It should have a flashing blue light. If it doesn’t, power cycle the IOIO. Connect the tablet Bluetooth to the IOIO box. Swipe down from the top of the screen to bring up the status bar, then hold down on the Bluetooth icon to bring up the settings.
Page 8 SmartMove Installation Guide Find the IOIO on the list (it will probably take a few seconds to resolve the name), tap it, and enter the PIN: 4545. Run the SmartMove Go app. The relay in the IOIO should click, and if wired up, the dome light will turn on.
Page 9: Wired Setup
Plug the other end of the USB cable directly into the tablet’s USB port. NOTE: The IOIO Box also charges your tablet so there is no need to remove for charging purposes. Version: 2.0 – May 2021...
Page 10: Tablet Setup
Select the “always open” option, then press OK. Sometimes the Android operating system will skip past this checkbox as it appears, but it is imperative that it gets selected and confirmed, otherwise the IOIO box will be unable to communicate with the SmartMove Go app.
Page 11 Login with the supplied Username and PIN. 6. Once the SmartMove Go is logged in, and the Cabcharge meter has booted up, engage the meter, let it tick a couple of times, then end the fare to check that it’s being correctly passed to SmartMove.
Page 12: Troubleshooting
 Force stop the app and re-start it. (Hold down on the app icon, tap “App info” and then “Force Stop” on the page that appears.)  If the “Allow SmartMove Go to access IOIO Standard Application” Dialogue (on page 10) disappeared before it was selectable, it may appear on disconnecting the reconnecting the USB.