Table of Contents
Advertisement
GREASING THE RACK
GREASING THE RACK
Between each use of the LOG SPLITTER, we recommend removing any debris caught on the Rail or Ram and
applying a rust preventative (Fluid Film or equivalent) to any bare metal areas on the top of the Rail (Fig. 7).
This will assure the smoothest return action of the Ram.
NOTE
Tools and Supplies needed:
• General Purpose Grease
• Clean Rags
• 13mm Wrench
1. Use a 13mm wrench to remove the Guard Screws that secure the flywheel Guard (Fig 8).
2. Remove the Guard Screws that secure the Flywheel and Belt Guard.
3. Disconnect the return spring.
4. Pull the Rack out and grease the Rack Teeth, top side of the Rack and the Pinion (Fig. 9).
5. Push the Rack back in and reinstall the Return Spring when finished greasing.
6. Reinstall the Guards.
Belt Guard
Guard
Screws
Folgen Sie allen Anweisungen dieser Betriebsanleitung! Die aktuelle Liste der Servicezentren finden Sie auf
der offiziellen Website des autorisierten Importeurs:
PROCEDURE
Check General Equipment Condition
Perform Rail Maintenance
Check Belt
Check the condition of the electrical cord.
Grease Rack
Clean Motor Exterior and Cooling Fins
It is important to grease the Rack every 5 hours for
proper operation.
Guard
Fig. 8
Screws
flywheel
Guard
REGULAR MAINTENANCE CHECKLIST
www.ks-power.de
Before each use
Pinion
Rack Teeth
Every 5 hours
Every 25 hours
www.ks-power.de/en
Fig. 9
7
| 6
Advertisement
Table of Contents
