Baninni LUIZ Manual page 35

MANUAL
1. Put the stroller on the brake and collapse it.
2. Press the handle adjustment button and slide the handle to the lowest height.
3. Press the release button on both sides and pull the seat to remove it.
4. Stand at the front of the stroller. Press the button in the direction of the arrows
and lift to fold the stroller.
5. Press the stroller down in the direction of the arrow.
6. Push the stroller down as far as it will go and secure the hook to prevent the strol-
ler from unfolding during transport.
Tip: You do not need to remove the seat to fold the pushchair if
there is only one seat on the frame.
Warning: Always take your child out of the stroller before folding
it.
1. To install the front seat adapter, insert the adapters into the hinge points on both
sides until you hear the click from each side.
2. To remove the front seat adapter, use your finger to separate the adapter's clam-
ping point. Pull on the adapter to remove it.
3. To install or remove the rear seat adapter, follow the same steps as 1 and 2.
3
Install or remove the seat adapters
1
4
2