Table of Contents
Advertisement
For safety reasons, } and in turn the
■
Flex start function will be
deactivated in the following
circumstances:
– Press A.
– Open the door.
– Programme end.
– Press # to switch off the
appliance.
– Power failure.
If the Flex start function is
deactivated, the ñ (Ready in) will
remain active.
Adding more laundry or removing
laundry:
If the Flex start function has
Note:
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
Press A (Start/Pause).
1.
Open the door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press A (Start/Pause).
5.
Press } (Remote Start).
6.
The FlexStart function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
Before the data can be transmitted,
■
the washing program must run
through to the end.
The washing machine must be
■
Home Connect-capable.
The washing machine and dryer
■
must be connected to your home
network and registered in your
Home Connect app.
Switch on the appliance.
1.
Set the program to Smart Dry Ç.
2.
The analysis starts.
To cancel the analysis, set a different
3.
program or switch the appliance off.
If an appropriate program has been
found, the LED associated with the
recommended program will be lit
continuously. If necessary, confirm the
notifications on the display. The
program information will then be shown
on the display.
Press A (Start/Pause).
4.
If a suitable program cannot be
Note:
found, an audible signal will sound and
There is no particular drying
programme recommended for the last
wash programme. will appear on the
display.
Possible reasons:
No suitable drying programs could
■
be found for the selected washing
program.
The washing machine and dryer
■
must be connected to your home
network and registered in your
Home Connect app.
Check whether your appliances are
■
within range of your home network.
No data is available for the last wash
■
program used. The data is stored for
24 hours and then deleted.
The washing program was aborted.
■
The washing program must run
through to the end.
Home Connect
en
43
Advertisement
Table of Contents
