Moldex TouchFree EcoStation User Instruction Manual

Mounting Template
TOP
Drill 1/4
Inch
Diameter
1. Tape template 45 inches above floor as shown.
2. Drill Holes.
3. Remove template off wall.
4. Screw in brackets.
5. Hang TouchFree EcoStation.
TouchFree EcoStation ™ User Instruction Manual
Drill 1/4
Inch
Diameter
Moldex
trademarks of Moldex. EcoStation
EARPLUGS & BOTTLE MADE IN THE USA
DISPENSER ASSEMBLY DESIGNED IN THE USA, MADE IN CHINA
Bottle Replacement Instructions
Fig. 1 Fig. 2
1. Peel off seal of refill bottle, taking care to remove any remnants (Fig. 1).
2. Remove dispensing assembly by gripping firmly and pulling off (Figs. 2 and 3).
3. Align dispenser assembly with new bottle, and pop on. Hang back on wall
bracket.
• Replace dispensing assembly if cracked, broken, worn, or if EcoStation
ceases to operate properly.
• After installing a refill, verify that the lid is secure and the dispenser
functions properly.
• Carry and handle the TouchFree EcoStation assembly by the bottle, not the
dispenser assembly.
• Please recycle empty EcoStation bottle. Empty bottles are fully recyclable.
, Ideas that wear well , SparkPlugs , Softies , Pura-Fit , Meteors
® ® ® ® ®
and TouchFree EcoStation are trademarks of Moldex-Metric, Inc. U.S. Patents Pending.
™ ™ ™
Fig. 3
, the PVC-Free logo and the random colored streaks and swirls are registered
®
6833-710 REV A 6/21