Advertisement
Quick Links
Advertisement
Summary of Contents for Mec MGG60
- Page 1 Picture may vary f rom the actual product )
- Page 2 Precautions & recommendations Parts & features Control panel description Lighting oven gas burner General informaion Important information 9-10 10-12 13-16 27-28 29-30 31-32 fully �...
- Page 3 upper This oven shall only be installed by a qualified licensed gas fitter. AVOID upper household use only...
- Page 4 Backsplash Control knob Light...
- Page 5 Backsplash Light...
- Page 6 Press the knob down for 3 seconds until the gas is ignited, then rotate to the left to 90°,...
- Page 7 Press the knob down for 3 seconds until the gas is ignited, then rotate to the left to 90°,...
- Page 8 4&5 3&6 Press the knob down for 3 seconds until the gas is ignited, then rotate to the left to 90°, temperature Press the knob down for 3 seconds until the gas is ignited, then rotate to the left to 90°, this location is the maximum firepower (Figure 5 &...
- Page 9 Press the rocker switch （ Figure part No. 7or 9 in Figure 3 or Figure 6 ） Press the oven burner control knob （ Figure part No. 5 or 6 in Figure 3 or Figure 6 a qualified and licensed gas fitfer. After Installation , make sure that all ratings are made correctly.
- Page 10 Correctly NEAR GAS （NG & ULPG） ��...
- Page 11 adequate...
- Page 12 shut off...
- Page 13 a qualified & licensed install...
- Page 14 Installation of the Backsplash Step 1:Put the backsplash on the rear part of the cooker. (see diagam) Step 2:Secure the backsplash on to the cooker from the back with the screws supplied Step 3:Secure the backsplash from the bottom. (see diagam) Step 4:Finished backsplash installation...
- Page 15 (220-240VAC)
- Page 18 NEED TO CONNECT THE G1/2 CORRUGATED PIPE !!!
- Page 19 NEED TO CONNECT THE G1/2 CORRUGATED PIPE !!! ULPG...
- Page 21 ULPG...
- Page 25 by qual fied & licensed gas fitter ULPG...
- Page 26 0.75...
- Page 37 Zhongshan Gensun Eelctric Appliance Co.,Ltd.
Need help?
Do you have a question about the MGG60 and is the answer not in the manual?
Questions and answers