Advertisement
3.
OPERATING INSTRUCTIONS
3.1.
ATTACHING PULLER TO LOAD AND THE ANCHOR.
WARNING! Ensure you have read, understood and
apply chapter 1 safety instructions before using the puller.
p
3.1.1. Secure hook and pulley to a rigid anchor which will take the
strain of the load to be pulled.
3.1.2. Secure the puller to the load to be pulled.
3.1.3. Depress the drive pawl spring in the direction of arrow
in figure 1. A.
3.1.4. Raise handle and hold firmly in this position, then depress stop
pawl in the direction of arrow “B”.
3.1.5. At the same time pull until desired slack has been taken up
between the anchor, puller and the load.
3.2.
APPLY TENSION
WARNING! Do Not overload.
3.2.1. Engage the drive pawl and ratchet wheel by pushing pawl
p
spring in the direction of arrow figure 2.A.
3.2.2. Each pull of the handle will wind the cable to pull the load.
3.3.
TO RELEASE THE TENSION
WARNING! Avoid abrupt handle movements, apply
pressure to handle with an even and steady force.
p
3.3.1. Depress the pawl spring in the direction of arrow in figure 3. A.
3.3.2. Very carefully and slowly push handle until drive pawl pushes
and disengages the stop pawl (not shown) to clear ratchet
teeth. This will release the load by one notch.
3.3.3. Repeat this handle motion as required to release the tension
one notch at a time.
3.3.4. When the tension has been fully released, check the load and
anchor to determine removal of the pulley hooks.
4.
MAINTENANCE
4.1.
CABLE REPLACEMENT.
A special quick-change designed “Keyhole” and a swayed end opening in the barrel of the ratchet wheel permits instant and secure
replacement of the cable.
1.
Pull all the cable off the ratchet wheel.
2.
”Snap” old cable out of the “Keyhole”.
3.
“Snap” the new cable into the “Keyhole”.
4.
Rewind the cable onto the ratchet wheel.
4.2.
CLEANING
Clean the puller after each use, and wipe the tool with a slightly oiled cloth, then store in a safe, dry, childproof place.
HAND POWER PULLERS Models HP700,
HP1000, HP1500.
EC Machinery Directive 98/37/EC
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required
for any claim. INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
Declaration of Conformity
are in conformity with the following EEC standards and directives
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
fig 1
fig 2
fig 3
We, the sole importer into the UK, declare that the products listed here
The construction files for these products are held by the Manufacturer and may be inspected on request
by contacting Jack Sealey Ltd
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products
01284 757500
25th November 1999
01284 703534
E-mail: sales@sealey.co.uk
HP700-1000-1500 (0016) -(3) - 010700
Advertisement
