Rcom 60 Important Information

RCOM CURADLE PET BROODER 60 OR 90 MODEL IMPORTANT INFORMATION
Please, leave the "NEW" Sticker on the front clear window. Removing it may leave the glue on the window and removing
the little glue with detergents or harsh chemicals may leave the clear window cloudy. Damage to the window caused by
the removal of the sticker is not covered under your warranty and replacement parts will be at your expense.
Please, set the temperature and humidity alarms for HI and LOW about two degrees above and below the desired
values. (Instructions included in the owner's manual)
1. The bottom drawer tray is intentionally manufactured so that is not easy to slide out at first. This is so that pets do not
push it out easily. However, this makes it hard to take out for the first few times. Please make sure to follow the steps
listed below for proper removal of the tray and to prevent damage to your unit.
a. Before removing the tray, make sure any tape, manuals, and packing material are removed from the inside.
b. Sometimes during shipping, the tray may get pushed back and become lodged in the track.
c. You need to wiggle the tray from side to side while pulling it out slowly. Make sure the drawer right and left edges are
centered. Please, make sure it is centered and apply even pull to get it out.
d. If the tray still remains "stuck" you will need to stand the machine it on the left side and push the tray out from the
back. This will make it easier to remove for the first time. Please note that the tray slides out in the direction of the
handles.
e. Please note, after removing the tray for the first time you may need to use a drop of cooking oil or food grade silicone
on the right and left side edges or tracks. This will help the tray to slide easily on the tracks and help prevent the tray
from becoming stuck.
2. Please make sure you are only using Distilled Water and no Fluoride. If the machine shows the build-up of calcium,
lime, or hard water deposits it could become damaged and not function properly. This is the reason that you must use
distilled water only. Distilled water is sold by the gallon at most grocery stores in the water section and then simply use
the gallon as the water container. Make sure to place this gallon of water lower than the bottom of the machine as
excess water in the tube needs to be able to gravity feed back to the jug. Next, place the supplied tube inside the water
jug and connect the other end of the tubing (following the instructions in the provided machine manual) to the machine
in order for the automatic water to work. This will allow the internal pump to draw in water as needed and prevent you
from having to add water manually to the internal water reservoir. Please note that the internal water pump will only
engage when water is called for. This means if the current humidity is set for 40% but the actual reading of humidity
internally is at 50% the pump will not engage until the internal humidity drops below 40%. The recommended starting
temperature and humidity settings can be accessed on the product page of our website under the "Manuals and
Instructions" tab and then located via the pdf titled "Incubator and Icu - Recommended Temperature, Humidity, and