Sony VGC-RB52 User Manual page 72

3.
Remove the side cover and place the unit on its side. See
4.
Configure the jumpers on your new drive as a slave, using the configuration instructions supplied with the drive.
5.
Detach the power and drive cables from the original hard disk drive in your computer.
6.
Release the drive holder from the chassis by removing the drive holder screw(s).
7.
Slide the drive holder out.
Rem ov ing the driv e holder
8. Slide the new drive into the drive holder, aligning the holes on each side of the drive to the holes in the drive
holder.
9. Secure the drive to the drive holder with screws.
Attaching the driv e screws
Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the new drive to the drive holder.
10. Realign the drive holder with the tracks on the inside of the chassis and slide the drive holder in completely.
Removing the side cover.
Page 72