Apollo Transport Folding-E Front Motor Drive System Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

Apollo Transport Folding-E

Front Motor Drive System

Owner's Manual

Table of Contents

Summary of Contents for Apollo Transport Folding-E Front Motor Drive System

Page 1 Apollo Transport Folding-E Front Motor Drive System Owner’s Manual...
Page 2: Table Of Contents
Contents Safety information ..............2 Riding the E-Bike ..............5 Product characteristics ............6 Product specification ............6 Display ................... 7 Battery ................... 7 Battery charger ..............8 Charging the battery ............8 Battery charge indication ............ 9 Battery LED indicators ............10 State of current charge ..............
Page 3: Safety Information
Safety information WARNING There is an increased risk of injury – even fatal – if you do not follow instructions. WARNING There is a risk of serious injury – even fatal – if you do not follow instructions. Managing the battery How safe maintenance is ensured ...
Page 4 Managing the battery WARNING  Do not subject the battery or the charger to physical shocks, e.g., by dropping. There is a danger of personal injury or property damage  Fluid that leaks from the battery pack may cause skin irritation or burns. In the event of accidental contact, rinse with water.
Page 5 WARNING  Please ensure that all carrier screws are fastened before riding；  Please note that the maximum load of the carrier is 25 kg, cargo weight shall not exceed 25 kg；  Please do not replace or modify the carrier； ...
Page 6: Riding The E-Bike
Riding the E-Bike Note: If the battery is not used for 4 hours or longer, it will automatically go into sleep mode. Press the power button on the battery for five seconds Press 2 sec. The handlebar display goes through a self-check routine, where all LEDs flash.
Page 7: Product Characteristics
Product characteristics Display Battery Motor Product specification Operating temperature range during discharge -20° C to 60° C Operating temperature range during charge 0° C to 45° C Storage temperature (battery) -20° C to 45° C Humidity (storage) up to 80% Charging voltage 100V to 240VAC Charging time...
Page 8: Display
Display ASSIST MODE BUTTON HIGH POWER ON/ OFF (press & hold for 2 seconds) BATTERY STATUS For WALK assistance press and hold the button Assistance will stop as soon as you release the button Battery Power Light Battery release key ON/OFF switch Important! Your bike is supplied with three battery lock keys;...
Page 9: Battery Charger
 If the E-Bike not in use, remove the battery and store it at a temperature between 0° C and 40° C in a dry environment.  Do not store the battery with low capacity for a longer period.  For storage, the battery should have a capacity of at least 40%.
Page 10: Battery Charge Indication
WARNING  Do not subject the battery or the charger to physical shocks, e.g., by dropping. Rinse in the event of accidental contact with water. If fluid gets in your eyes, seek medical advice. Fluid that leaks from the battery pack may cause skin irritation or burns. ...
Page 11: Battery Led Indicators
Battery LED indicators State of current charge There are 4 LEDs on the battery display, these are lit in sequence to show the state of charge of the battery when charging. LED Board Appearance Indicator Remark LED 1: Flashing < 20% Start charge Steady =>20% &...
Page 12: Fitting The Battery
Fitting the battery 1. Push the battery into the battery cradle until it is fully installed in place. 2. Turn the key 180°to lock the battery. Removing the battery Unlock with the key & slide out the battery...
Page 13: Assistance Levels And Speed
Assistance levels and speed Miles per hour 15.5 12.5 Range Factors which affect the range The above figures are based on a speed of 20 km/h on a level road at 15° C–20° C. The range is influenced by many factors: ...
Page 14: Removing The Front Wheel (To Repair A Puncture)
Removing the front wheel (to repair a puncture)  Take off the two cable ties holding of the wire harness and unplug the two parts of the motor connector.  Release the two „arms‟ of the front V brake by pulling on the front brake cable „noodle‟...
Page 15 is pointing directly downwards to align the anti-rotation toothed washers on the wheel axle with the dropout slots.  Firmly tighten both wheel nuts to 40 +/-5 Nm  Push the two parts of the motor cable connector together, making sure that the moulded arrows are aligned ...
Page 16: Ec Declaration Of Conformity
A copy of the Technical file for this equipment is available from:- the EU address above. Description of Equipment Battle E-Bike Halfords Apollo Transport 250 W Front Motor Drive System, 8.7Ah Li-Ion Battery & Battery Charger The following harmonized standards have been used:- EN 15194:2009 + A1:2011 Cycles –...
Page 17: Halfords E-Bike Specific Warranty Conditions
Halfords e-bike specific warranty conditions Your Apollo Transport e-bike is guaranteed against manufacturing defects arising from faulty workmanship or materials for 2 years from the original date of sale. Providing that the cycle:  Has been properly cared for, regularly serviced and maintained.
Page 18: Battery Pack Specific Warranty Conditions
Battery pack specific warranty conditions The battery pack is guaranteed over the warranty period to provide a minimum of 500 charging cycles and to hold at least 60% of its nominal battery capacity. This is dependent upon the correct use, regular re-charging, correct preparation for storage and storage (as detailed in the BATTLE Owner‟s Manual).