Chevrolet 2004 Malibu Owner's Manual page 125

Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.
Headlamps On Reminder
If you open the driver's door and turn off the ignition while
leaving the lamps on, you will hear a warning chime.
Flash-to-Pass Feature
This feature lets you use your high-beam headlamps
momentarily to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
When the high beams
are on, a light on the
instrument panel cluster
also will be on if the
ignition is in ON.
Windshield Wipers
Use this lever located on the right side of the steering
wheel to operate the windshield wipers.
9 (Off): Move the lever to this position to turn off the
windshield wipers.
& (Intermittent): Move the lever to this position to
choose a delayed wiping cycle. Turn the intermittent
adjust band down for a longer delay or up for a shorter
delay. The wiper speed can only be manually adjusted
when the lever is in this position.
& (Speed Sensitive Wipers): Move the lever to
this position for speed sensitive operation. When you
select this position, the delay will change with your
vehicle's speed. The delay will decrease as you
go faster and increase as you go slower.
3-9