Table of Contents
Advertisement
Available languages
Available languages
Speed 3: the number "3" appears on
the display
High-speed: the number "4" appears
(flashing) on the display
The high-speed function is regulated by
a timer. The standard time setting is 5',
at the end of which the hood adjusts to
speed 2.
Press button
2
to deactivate this
function before the set time expires;
the hood will adjust to speed 1. Press
button
1
to turn the hood off.
3
Lights ON/OFF button
4
Speed timer button
5
Display
Speed timer button
Press button
4
to activate the speed timer;
the hood turns off once the set time expires.
The timer functions in the following way:
•
Speed 1 - 20 minutes (the number "1"
and a small flashing LED light appear
on the display)
•
Speed 2 - 15 minutes (the number "2"
and a small flashing LED light appear
on the display)
•
Speed 3 - 10 minutes (the number "3"
and a small flashing LED light appear
on the display)
•
High-speed - 5 minutes (the number
"4" and a small flashing LED light
appear on the display)
Press button
1
or button
hood off while the speed timer is in function;
by pressing button
2
the set speed.
Saturation indicator of the grease filter
After 80 hours of operation, the display
shows alternately the set speed and the
letter "F".
Saturation indicator of the charcoal filter
After 320 hours of operation, the display
shows alternately the set speed and the
letter "C".
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button
1
for about 3 seconds.
Perform filter maintenance as
recommended in this manual.
4
to turn the
, the hood returns to
In the event that both indicators of filter
saturation "F" and "C" start flashing,
proceed with the reset twice.
The saturation indicator of the charcoal
filter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the first time.
Activation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
buttons
2
and
3
for 3 seconds.
The letters "F" and "C" will flash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal filter.
Deactivation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
the buttons
2
and
3
letter "F" will flash on the display for 2
seconds, to indicate successful deactivation
of the saturation indicator of the charcoal
filter.
6. LIGHTING
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the
LED light.
For replacement, contact the technical
service.
ENGLISH
5
for 3 seconds. Only
Advertisement
Table of Contents
