Subscribe to Our Youtube Channel
Summary of Contents for Belson Outdoors T22-02
- Page 1 111 North River Road North Aurora, IL 60542 Phone: (800) 323-5664 Fax: (630) 897-0573 sales@belson.com Model # T22-02 Instructions Sheet 22 GALLON RECYCLED PLASTIC TRASH RECEPTACLE www.belson.com...
- Page 2 BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED. D - BAG HOLDER ( 2 ) - TWO BAG HOLDERS FP - FASTENER PACK ( 1 ) - ONE FASTENER PACK C - FRAME RING ( 2 ) - TWO FRAME RINGS E - FLAT TOP ( 1 ) - FLAT TOP B - SIDE BOARD W/ PILOT HOLES...
- Page 3 BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED. 72 - #12 X 2” FLAT HEAD PHILLIPS SCREWS 4 - #12 X 1-1/2” PAN HEAD PHILLIPS SCREWS 8 - 1/4” FLAT WASHER ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS: 1 - 3”...
- Page 4 STEP #1: PLACE THE ( 2 ) TWO FRAME RINGS ON EDGE WITH THE LONG EDGE ON A FLAT SURFACE AS SHOWN IN THE DIAGRAM ABOVE. ONE AT A TIME, PLACE ( 4 ) FOUR SIDE BOARDS IN POSITION MAKING SURE THE HOLES LINE UP WITH THE PRE-DRILLED PILOT HOLES IN THE FRAME RINGS.
- Page 5 #12 X 2” FLAT HEAD PHILLIPS SCREW STEP #2: REPEAT STEP #1 FOR THE OPPOSITE SIDE. www.belson.com...
- Page 6 #12 X 2” FLAT HEAD PHILLIPS SCREW STEP #3: PLACE ( 1 ) ONE SIDE BOARD W/ PILOT HOLES IN THE CENTER POSITION MAKING SURE THE HOLES LINE UP WITH THE PRE-DRILLED PILOT HOLES IN THE FRAME RINGS. FASTEN USING ( 1 ) ONE 2” FLAT HEAD PHILLIPS SCREW PER HOLE.
- Page 7 STEP #4: ONE AT A TIME, PLACE ( 4 ) FOUR SIDE BOARDS IN POSITION MAKING SURE THE HOLES LINE UP WITH THE PRE-DRILLED PILOT HOLES IN THE FRAME RINGS. FASTEN USING ( 1 ) ONE 2” FLAT HEAD PHILLIPS SCREW PER HOLE. #12 X 2”...
- Page 8 STEP #6: TURN THE TRASH RECEPTACLE UPRIGHT ONTO ITS BASE. PLEASE USE CAUTION WHILE MOVING. AT THIS POINT IN ASSEMBLY THE RECEPTACLE WILL WEIGH APPROXIMATELY 66 POUNDS. #12 X 1-1/2” PAN HEAD PHILLIPS SCREW 1/4” FLAT WASHER STEP #7: PLACE THE BAG HOLDER IN THE TRASH RECEPTACLE, USING ( 1 ) ONE 1/4” FLAT WASHER ON EACH SIDE OF THE PRE-DRILLED HOLES, FASTEN WITH ( 1 ) ONE 1-1/2”...
- Page 9 STEP #8: REPEAT STEP #7 FOR THE OPPOSITE SIDE. STEP #9: TO PLACE THE LID ON THE TRASH RECEPTACLE, REST IT ON THE INNER LEDGE OF THE SIDE WALLS. www.belson.com...
Need help?
Do you have a question about the T22-02 and is the answer not in the manual?
Questions and answers