Table of Contents
Advertisement
Quick Links
PRESTO
HeatDish
Parabolic Electric Heater
The
parabolic reflector focuses
energy like a satellite dish.
e
Warmth you can feel directly,
almost instantly.
e
Tilts high, low, or anywhere
in-between to direct heat
right
where you want.
Heats you rather
Keeps you testy warm
!
even
*
Although it will keep you warm in a large, enclosed area, the
heater is not designed to
heat the
heating enclosed rooms up to 10 by 12 feet (3 x 4m).
Estas instrucciones también estan disponibles en espaiiol.
Para obtener una copia impresa:
¢
Descargue
en
formato
Envie un mensaje de correo electrénico a contact@GoPresto.com.
+
Llame
al
1-800-877-0441,
INSTRUCTIONS
©2021
National Presto Industries, Inc.
"TILT
L . B
than the air.
room
entire
room. Effective for
PDF
en
www.GoPresto.com/espanol.
oprima
2
y
deje
un
Mf,
ZS
TT
\\
Ci
mensaje.
|
Gi}
i
WS
QSL
Seg
1000 Watts
3412
120 Volts AC
Visit www.GoPresto.com
Form 4058-006A
BTUs
Advertisement
Table of Contents
Related Manuals for Presto HeatDish+Tilt
Summary of Contents for Presto HeatDish+Tilt
- Page 1 Estas instrucciones también estan disponibles en espaiiol. Para obtener una copia impresa: ¢ Descargue formato www.GoPresto.com/espanol. Envie un mensaje de correo electrénico a contact@GoPresto.com. 1000 Watts Llame 1-800-877-0441, oprima deje mensaje. 3412 BTUs 120 Volts AC Visit www.GoPresto.com INSTRUCTIONS ©2021 National Presto Industries, Inc. Form 4058-006A...
- Page 2 Discard the heater or return it to the Presto Factory Service Department for examination and/or repair.
- Page 3 GETTING ACQUAINTED WITH YOUR HEATER Before using YourPresto® HeatDish® Plus Tilt parabolic electric heater for the first time, familiarize yourself with the parts of the heater and read the information on the following pages. The heater is shipped in the storage Fig.
- Page 4 How the Parabolic Heater Works An automatic control switch, or thermostat, is built into the heater to control the heat output. The control knob (Fig. C), located on the top of the heater, is used to adjust the thermostat. This thermostat works like the control for a burner on an electric stove by cycling the heating element on and off to regulate the amount of heat produced.
- Page 5 she heater js controlled by a thermostat that shuts the Fig. C Red power ier off ifit overheats, It 1s placed too close to oF t0 8 wall or if too much dust or dirthas Teset button cumulated on the parabolic reflector. To ensure that ace are aware that an overheat situation has occurred he heater will turn off and buzz until youmanually reset it.
- Page 6 AC outlet, this poor connection may cause overheating and distortion of the plug. If the plug is distorted, please discontinue use of the heater, and we suggest you contact the Presto Consumer Service Department. The signal light will glow whenever the cord is plugged into an outlet to indicate the heater is electrically activated.
- Page 7 1 knob is turned mbet, after the contro ed to any ON atinually turn itself ON and OFF to contr. Position below HI, the heater ol the heat output. will ious; This always be obvious; due to residual heat in the heating element, it will con ht clicking or hummin Jow at most settings.
- Page 8 This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This is Presto’s personal pledge to you and is being made in place of all other express warranties.
Need help?
Do you have a question about the HeatDish+Tilt and is the answer not in the manual?
Questions and answers