Advertisement
Available languages
Available languages
Getting to Know your Can Opener
1. Lever
2. Magnet
3. Geared Wheel
4. Base
5. Bottle Cap Opener
6. Cutting Blade
7. Guide Bar
OPERATING INSTRUCTIONS
IMPORTANT: To ensure continued efficient performance, keep the Cutting Blade clean. Electric
Can Opener should be turned off for one minute after operating for 5 minutes.
An y other service should be performed by a n authorized service representative.
BEFORE USING
1. Carefully unpack Can Opener.
2. Wipe with a soft cloth or sponge to remove small particles collected during packing and
handling.
3. Attach the magnetic part (used to hold the can in place when cutting) to the front panel of the
lever by sliding it down over the "hook", with the circular surface facing down. Press down
firmly in place until top surface is flush with the lever.
4 . Plug Can Opener into electrical outlet, and press down on the Lever to make sure it is operat-
ing properly.
CAUTION: Do not place finger underneath the Lever where the Cutting Blade and Geared
Wheel are located; doing so may cause injury.
CAUTION: Never remove the magnet without first unplugging the cord and returning the lever
to its flush, horizontal position
TO USE CAN OPENER
1. Place Can Opener on level surface.
2. Raise Lever, place can under the Guide Bar and against the Geared Wheel. (See Figure 1 to
identify parts). Make sure the magnet sticks completely to the top of the can.
3. Have one hand poised to grasp the can. With the other, press down on the Lever to pierce lid
of can. This automatically starts the cutting action. The Can Opener will continue to cut until
the lid is completely severed from the can.
4. Grasp the can, then raise the Lever to release the can.
5. Carefully remove lid from the magnet.
USE CAUTION TO AVOID INJURY FROM EDGE OF LID.
1
7
2
3
4
TO USE KNIFE/SCISSORS SHARPENER
1. Place Knife Blade lightly in either left or right groove. Draw Knife slowly toward you with a
slow, even motion.
2. Place Blade in other groove and do the same. Repeat this alternating action 4 or 5 times,
from one groove to the other until desired sharpness is achieved.
6
3. The Knife/Scissors Sharpener can also be used for sharpening scissors. A large groove at
the side of the Sharpener is designed especially for scissors. Place one blade of the scissors
in the groove, and then draw it toward you slowly and evenly. Repeat with the other blade.
5
ATTENTION: Blades to be sharpened should be clean. Do not sharpen knives that have ser-
rated blades.
TO USE BOTTLE OPENER
1. Unplug appliance from electrical socket.
2. Place Can Opener on a level surface. To steady position one hand on top of the Can Opener.
3. Place bottle cap edge under Opener Flange.
4. Apply pressure on bottle downward until bottle cap pops off
NOTE: This bottle opener is not recommended for bottles having "Twist-Off" caps.
Advertisement
