Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ebac SD100
Summary of Contents for Ebac SD100
- Page 1 Drawing No. :- TPC210 Issue :- 3 Date :- 22/06/05 EBAC MODEL SD100/SD200 INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL Ebac Industrial Products, Inc. 700 Thimble Shoals Blvd, Suite 109 Newport News, VA. 23606-2575 Tel: (757) 873 6800 Fax: (757) 873 3632 Website www.ebacusa.com...
- Page 2 :- 22/06/05 UNPACKING Carefully remove the SD100/SD200 dehumidifier unit from its transit box and visually check for signs of transit damage. If there is evidence of damage DO NOT attempt to operate the unit, call your supplier for advice. Do not discard the packing, it will be useful when transporting the dehumidifier unit in the future.
-
Page 3: Specifications
EIGHT 26” 26” IDTH 26” 26” EPTH 143 lbs 172 lbs EIGHT Low 560 CFM Low 560 CFM IRFLOW High 760 CFM High 650 CFM ORSEPOWER 110V–115V/60Hz/1ph 208V-230V/60Hz/ ph OWER UPPLY Powder-coated Epoxy Powder-coated Epoxy INISH EFRIGERANT SD100/SD200 OWNERS MANUAL... -
Page 4: Installation
However if a damp patch is particularly apparent the outlet grille should be pointed towards it. NOTE: Both inlet grille and outlet grille of the dehumidifier unit must have clear space around them and not be obstructed in anyway. SD100/SD200 OWNERS MANUAL... -
Page 5: Operation
:- 22/06/05 OPERATION The following procedures should be followed to test the SD100/SD200 for correct operation: 1) After unpacking, examine all external features to confirm damage-free shipment. Report all defects and damage at one. Connect the power cable to a grounded power source. -
Page 6: Routine Maintenance
Partial frosting accompanied by frosting of the thin capillary tubes, indicates loss of refrigerant gas or low charge. Check all wiring connections. F ANY OF THE PRECEDING PROBLEMS OCCUR CONTACT THE ERVICE ENTER PRIOR TO CONTINUED OPERATION OF THE UNIT TO PREVENT PERMANENT DAMAGE SD100/SD200 OWNERS MANUAL... - Page 7 An open circuit indicates that the compressor should be replaced. c. Check that the compressor is not grounded by establishing that a circuit does not exist between the compressor terminals and the shell of the compressor. SD100/SD200 OWNERS MANUAL...
-
Page 8: Troubleshooting
2. Ensure that no section of the drain machine 2. Drain pipe too high hose is above the level of the water outlet Ebac Industrial Products, Inc. 700 Thimble Shoals Blvd, Suite 109 Newport News, VA. 23606-2575 Tel: (757) 873 6800 Fax: (757) 873 3632 Website www.ebacusa.com... -
Page 9: Rating Plate Information
4.2 Liters/Hr OISTURE EMOVAL 1120 Grams 1650 Grams EFRIGERANT 115 Volts 208/230 Volts OLTAGE 1100 2100 Single Single HASE 60 Hz 60 Hz 9.2 Amp 9.6 Amp 24 Volt 24 Volt ONTROL OLTAGE 15 A 15 A ELAY SD100/SD200 OWNERS MANUAL... - Page 10 Fan Blade 3840404 3840404 Fan Motor 3830112 3830109 (Humidistat) Terminal Block (Power) Terminal Block (Transformer) Terminal Block Contactor 3830306 3030306 Transformer Fan Motor Capacitor Compressor Capacitor 3830803 3830903 Defrost Control Switch 3831516 3831512 Intake Filter 3910306 3910306 SD100/SD200 OWNERS MANUAL...
-
Page 11: Limited Warranty
Our products carry a one-year unconditional warranty against any defects in workmanship or material. This warranty will cover all parts and labor required to repair your Ebac product. This warranty is invalid if the unit has been abused, damaged, whether intentional or accidental, or if any modifications have been made to the unit.
Need help?
Do you have a question about the SD100 and is the answer not in the manual?
Questions and answers