Table of Contents
Advertisement
Situation
The door opens but
won't dose:
The door reverses for
no apparent reason
and opener lights
don't blink:
The door reverses for
no apparent reason
and opener lights
blink for 5 seconds
after reversing:
The opener light:
The opener strains or
maximum force is
neected to operate
door:
The opener motor
hums briefly, then
won't work:
The opener won't
operate due to
power failure:
Vie chain droops
or sags:
Having a Problem?
Probable Cause
Solution
&
1. If the opener lights blink, check the safety reversing sensor. See page 23.
2. If the opener lights do not blink and it is a new installation, check thè down force.
See Adjustment Step 2, page 29. For an existing installation, see below.
Repeat the safety reverse test after the adjustment is compiete.
1. Is something obstructing the door? Pull the red emergency release handle. Operate
the door manually. If it is unbalanced or binding, call for professional garage door
service.
2. Clear any ice or snow from the garage floor area where the door closes.
3. Review the force adjustment procedures on page 29.
fuiiy dosedpo5\W on,
4. If door reverses in the
Repeat safety reverse test after adjustments to force or travel limits. The need
for occasional adjustment of the force and limit settings is normal. Weather
conditions in particular can affect door travel.
Check the safety reversing sensor. Remove any obstruction or align the receiving eye.
See page 23.
.. - doesn't turn on:
Replace the light bulbs (75 watts maximum). Use a
bulb if regular bulb burns out.
,., doesn't turn off:
orP.
Is the Light feature
The door may be out of balance or the springs are broken.
emergency release to disconnect the trolley. Open and close the door manually. A properly
balanced door will stay in any point of travel while being supported entirely by its springs. If it
does not, disconnect the opener and call a professional garage door serviceman.
increase the force to operate the opener.
1. The garage door springs are broken. See above.
2. If the problem occurs on the first operatbn of the opener, door may be locked.
the door lock.
If the chain was removed and reinstalled, the motor may be out of phase.
Remove the chain; cycle the motor to the down position. Observe the drive sprocket.
When it turns in a clockwise direction and stops in the down position, reinstall the chain.
Repeat the safety reverse test after the adjustment is complete.
1. Use the emergency release to disconnect the trolley. The door can be opened and closed
manuEdly. When the power is restored, press the Door Control push bar or button and
trolley will automatically reconnect (unless trolley is in lockout position.) See page 32.
2. The Emergency Key Release accessory (for use on garages with no service door)
disconnects the trolley from outside the garage in case of power failure.
It is normal for the chain to droop slightly in the closed door position. Use the
emergency release to disconnect the trolley. If the chain returns to normal height when
the trolley is disengaged and the door reverses on a one-inch board, no adjustments
are needed (see page 11).
(continued)
standard neck qaxB/Qe
off.
Turn it
35
decrease the travel limits (page 28).
Close the door
and use the
Disable
door opener
Do not
Advertisement
Table of Contents
