Summary of Contents for Pentax T18 Series
- Page 1 User Manual Version 1.00 Revision Version 1.00, September 2020 TI Asahi Co., LTD Page | 0...
- Page 2 T18 User Manual © 2017 TI Asahi Co., Ltd. All rights reserved. PENTAX, the PENTAX logo are trademarks registered in the U.S. and other countries. No part of this document may be copied, used or reproduced without the prior written permission of TI Asahi.
-
Page 3: Table Of Contents
Table of Content 1. Introduction ......................4 1.1. Features ......................4 1.2. Keyboard ......................4 1.3. LED Functions ..................... 6 Getting Acquainted ....................6 2.1. Installing the TF card/SIM card/Battery............... 6 2.2. Charging ......................7 2.3. Turning the collector on/off ................7 2.4. - Page 4 Accessories ......................14 4.1. Standard Accessories ..................14 4.2. Optional Accessories ..................15 Environmental Specifications ................15 Warranty Terms ....................15 Appendix – Product Safety Warnings ..............16 Page | 3...
-
Page 5: Introduction
1.Introduction 1.1. Features The following section describes the general features of the T18 Handheld Controller. Figure 1-1: General Diagram 1.2. Keyboard The yellow symbols are system defaults. Page | 4... - Page 6 Table 1-1. Keyboard Function System defaults to the digital input method System Default Lowercase letters Switch between / and - Press↑（shift） Press↑(shift) again, to switch to digital input method. Capital letters Switch between / and - Press Caps Press the Caps button again for lowercase letters. Page | 5...
-
Page 7: Led Functions
1.3. LED Functions Table 1-2, LED Functions Operation Power off Charging Fully of charged In use LED Status Red light on Getting Acquainted 2.1. Installing the TF card/SIM card/Battery Turn the back cover screw to the open position according to the instructions on a label in the box, and take off the back cover. -
Page 8: Charging
Figure 2-3: Inserting the Battery Close the back cover and turn the back cover screw to the lock position. 2.2. Charging DC adapter: Open the DC IN cover on the right side of the device, and charge with the DC adapter. Charging current can reach 2A. -
Page 9: Installing Applications
2.5. Installing Applications 2.5.1. Installing Applications via ActiveSync or WMDC Make sure the T18 is connected with your PC via ActiveSync or WMDC. Figure 2-4: T18 Connected with PC Click the installation file on your PC to start the installation of an application. Figure2-5: Installing the Applicationg Select an installation directory in the T18（Flash Storage is suggested）, and tap install. -
Page 10: Directly Installing Applications
Figure 2-6: Choosing Install Location NOTE: We suggest installing the application in Flash Storage, and saving your data to a TF card. 2.5.2. Directly Installing Applications If the installation file is compatible on mobile devices, copy the file into the T18 and tap the file to directly start the installation. -
Page 11: Camera
Figure 2-7: GNSS Status Tap OK Figure 2-8: GNSS Status 2.7. Camera Select Start>Picture & Video, select Camera or the camera key icon to take photos. Press the camera key (F3) to take photos. Tap screen and select OK to exit. 2.8. -
Page 12: Long Range Bluetooth (Optional)
2.9.2. Long Range Bluetooth (Optional) Select Start>Settings>System, and tap Bluetooth Radio Manager. Figure 2-9: Bluetooth Radio Manager Chose the module DirectConn, and tap Power On. Tap Search BT to start searching for BT devices. After all BT devices have been found, select a device. Tap Connect to pair with a BT device of your choice. -
Page 13: Wi-Fi
Figure 2-11: BT Manager-Status Tap Setup to setup this Bluetooth, as shown below. Figure 2-12: BT Manager-Setup The default baud rate is 38400. The PIN code refers to the pairing PIN code of the BT device which T18 want to pair with. If you check Auto Conn, T18 will automatically connect to the last pairing BT device when powered up. -
Page 14: Gprs/3G Data Connection
2.9.4. GPRS/3G Data connection Make sure there is a SIM card in the T18. Select Start>Settings>Connections>Connections. Tap Add a new modem connection. Input connection name, select Cellular Line (GPRS), and tap Next. Input Access point name, tap Next. Tap Finish and add new connection successfully. Tap Manage existing connections. -
Page 15: Clean Boot
Select Start> Settings> System> Power> Advanced, set the power off time in different conditions. Backlight will be off according to selected settings. Figure 3-4: Go-to-Sleep Mode 3.5. Clean Boot Select Start> Settings> System> Clean Boot, to restore factory default settings according to the guide. Figure 3-5: Clean Boot NOTE: The password is “1234”. -
Page 16: Optional Accessories
Warranty service may be obtained from an authorized PENTAX warranty service dealer. If this product is delivered by mail, purchaser agrees to insure the product or assume the risk of loss or damage in transit, to prepay shipping charges to the warranty service location and to use the original shipping container or equivalent. -
Page 17: Appendix - Product Safety Warnings
The purchaser’s sole remedy shall be replacement as provided above. In no event shall PENTAX be liable for any damages or other claim including any claim for lost profits, lost savings or other incidental or consequential damages arising out of the use of, or inability to use, the product. - Page 18 CAUTION! CONNECTION TO A USB INTERFACE MUST BE LIMITED TO USB2.0 VERSION OR HIGHER CONNECTION TO “POWER USE” MODE IS PROHIBITED. Page | 17...
Need help?
Do you have a question about the T18 Series and is the answer not in the manual?
Questions and answers