Earbuds Pairing/Connecting; Function Operation-Use One Earbud - SACKit Rock 250 User Manual

4.Earbuds pairing/connecting

Please use this step if two headset can not be connect with each
other.
1.Turn off two earbuds respectively(don't put them into the charging case).
2.Clear the pairing list: Choose one of the earbuds. Firstly, enter the pairing
mode. Then hit the touch button 5 times, while the red light turns on for 1
second. The pairing list will be cleared when emits Four Tone_High Falling
after a "dang" prompt. The other headset cleans the pairing list by doing the
same.
3.The earbuds will enter TWS pairing mode automatically when they are
turned on (indicator light status: red and white lights flash slowly).After
successful connection, the master earbud(L) will emits Two Tone_Low
Rising after a "dang" prompt, which indicator light status will be: red LED
and white LED flash alternately(it keeps waiting to be paired with your
phone), while the slave earbud(R) will emits 'Dang' and indicator status
will be: white LED flash twice time every 10 seconds.
Remarks:
In normally the two earbuds will connect automatically once you have

taken out of the charging case,which set in factory.
You can connect the two earbuds according above operation if they failed

connecting.

5.Function operation-use one earbud

5