Advertisement
After power is turned on, we could measure 7 channels PWM waveform
at four connectors easily. Any abnormal of PWM waveform may be
caused by PWM IC or power output section (MOSFETs & drive ICs).
SL----SR
FL----FR
PWM waveform 4.2V p-p
'AMP –B'+4.2V
AMP -B
Master Clock 5V p-p
Quick check PWM waveform
7 channels
(CN521)analog
audio signal.
SBL--SBR
PWM at two
end pins on
3connectors
C
RED PIN
FW323
PIN 4
820 Ohm-
Without AC power the resistance
form 'AMP_ -B' to each of 7 CHs.
PWM pin should be 820 Ohms. If
is too low, the drive IC at the next
power amp stage is defective.
Hide quick links:
Advertisement
