Advertisement
en Avoiding material damage
WARNING ‒ Risk of injury!
Components inside the appliance may have
sharp edges.
▶ Carefully clean the appliance interior.
Items placed on the appliance may fall off.
▶ Do not place any objects on the appliance.
Changes to the electrical or mechanical as-
sembly are dangerous and may lead to mal-
functions.
▶ Do not make any changes to the electrical
or mechanical assembly.
The filter cover may swing out.
▶ Open the filter cover slowly.
▶ Take hold of the filter cover after opening
until it no longer swings out.
▶ Close the filter cover slowly.
Risk of injury when opening and closing the
hinges.
▶ Keep your hands away from the hinges.
The light emitted by LED lights is very
dazzling, and can damage the eyes (risk
group 1).
▶ Do not look directly into the switched-on
LED lights for longer than 100 seconds.
WARNING ‒ Danger: Magnetism!
The appliance contains permanent magnets.
They may affect electronic implants, e.g.
pacemakers or insulin pumps.
▶ Persons with electronic implants must
stand at least 10 cm away from the appli-
ance.
2 Avoiding material damage
ATTENTION!
Condensate may cause corrosion damage.
To prevent condensation from building up, switch on
▶
the appliance during cooking.
If moisture gets into the controls, this may result in
damage.
Never clean controls with a wet cloth.
▶
Incorrect cleaning damages the surfaces.
Follow the cleaning instructions.
▶
Do not use harsh or abrasive detergents.
▶
Clean stainless steel surfaces in the direction of the
▶
finish only.
Never clean controls with stainless steel cleaners.
▶
4
WARNING ‒ Risk of electric shock!
If the appliance or the power cord is dam-
aged, this is dangerous.
▶ Never operate a damaged appliance.
▶ Never pull on the power cord to unplug the
appliance. Always unplug the appliance at
the mains.
▶ If the appliance or the power cord is dam-
aged, immediately unplug the power cord
or switch off the fuse in the fuse box.
▶ Call customer services. → Page 9
Incorrect repairs are dangerous.
▶ Repairs to the appliance should only be
carried out by trained specialist staff.
▶ Only use genuine spare parts when repair-
ing the appliance.
▶ If the power cord of this appliance is dam-
aged, it must be replaced by trained spe-
cialist staff.
An ingress of moisture can cause an electric
shock.
▶ Before cleaning, pull out the mains plug or
switch off the fuse in the fuse box.
▶ Do not use steam- or high-pressure clean-
ers to clean the appliance.
WARNING ‒ Risk of explosion!
Highly caustic alkaline or highly acidic clean-
ing agents in conjunction with aluminium parts
in the interior of the appliance may cause ex-
plosions.
▶ Never use highly caustic alkaline or highly
acidic cleaning agents. In particular, do not
use commercial or industrial cleaning
agents in conjunction with aluminium parts,
e.g. grease filter on extractor hoods.
Condensation that flows back in may damage the ap-
pliance.
The air extraction duct must be installed with a
▶
gradient of at least 1° from the appliance.
If you put incorrect stress on the design elements, they
may break off.
Do not pull design elements.
▶
Do not place objects on the design elements or
▶
hang objects from them.
There is a risk of surface damage if you do not peel off
the protective film.
Remove the protective film from all parts of the ap-
▶
pliance before using for the first time.
Advertisement
