Advertisement
2. INTRODUCTION & SPECIFICATION
manufactured from durable composite material, ergonomically
designed to pivot on a 180° axis, maximising the volume and
direction of air flow. Featuring three speed settings, which can
ideally be used for intense cooling power or as an air circulator for
the whole room. Fitted with Bs fully approved plug.
Model No: . . . . . . . . . . . . . . SFF20
Fan diameter:. . . . . . . 500mm (20")
speeds: . . . . . . . . . . . . . . . . . . . . 3
motor Power: . . . . . . . . . . . . . .70W
supply: . . . . . . . . . . . . . . . . . . 230V
Height: . . . . . . . . . . . . . . . . 610mm
3. OPERATION
WARNING! Ensure that you read, understand and apply safety instructions
in Section 1 before using fan.
3.1.
check that the speed control is set to "0" (off) and then plug into the mains power
supply and switch the power on.
3.2.
the fan features 3 speeds which are selectable using the switch located
on the top.
3.3.
Adjust the direction of the air flow by moving the base from side to side and tilting
the fan up or down.
3.4.
When you have finished using the fan ensure you turn the speed control switch
to "0" (off) and disconnect the fan from the mains power.
4. CARE OF FAN
WARNING! Ensure that the fan is disconnected from the mains power supply
before attempting any of the following:
4.1.
use a soft, damp cloth to clean the fan.
DO NOT immerse the fan in water and never allow water to drip onto the motor
housing. DO NOT use solvents, petroleum, paint thinner or other chemicals to clean
the fan.
4.2.
to clean the fan blade, undo the four screws on the back and seven clips,
accessable from the front, and remove the front grille.
clean the blade with a slightly damp cloth. replace the front grille and refit the clips
and screws.
4.3.
should the motor, switch or the power lead require service or maintenance contact
your local service agent.
4.4.
When not in use place the fan in its original box or otherwise cover to protect
from dust, and store in a safe, dry, childproof location.
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey limited
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
Original Language Version
WEEE Regulations.
dispose of this product at the end of its working life in compliance
with the eu directive on Waste electrical and electronic equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
www.sealey.co.uk
Web
sales@sealey.co.uk
email
sFF20 Issue: 1 - 15/01/13
Advertisement
