Advertisement
Quick Links
AUTOMATION
FOR BARRIERS
WARNING!! Before installing, thoroughly read this manual that is an integral
part of the pack
Our products if installed by qualified personnel capable to evaluate risks,
comply with norms UNI EN 12453, EN 12445
The CE mark conforms to European directive
EEC 89/336 + 92/31 + 93/68 D.L. 04/12/1992 N. 476.
Advertisement
Related Manuals for vds BEV 2
Summary of Contents for vds BEV 2
- Page 1 AUTOMATION FOR BARRIERS WARNING!! Before installing, thoroughly read this manual that is an integral part of the pack Our products if installed by qualified personnel capable to evaluate risks, comply with norms UNI EN 12453, EN 12445 The CE mark conforms to European directive EEC 89/336 + 92/31 + 93/68 D.L.
-
Page 2: Table Of Contents
PACKING CONTENTS ................ TECHNICAL DATA................DIMENSIONS ..................CONSIDERATIONS FOR INSTALLATION.......... INSTALLATION..................4-5-6 TROUBLESHOOTING................SAFETY PRECAUTIONS ..............PACKING CONTENTS 1- BARRIER 1- BAR SUPPORT 1- UNLOCKING KEY 1- CONDENSER (230Vca) BEV2 TECHNICAL DATA BEV2 FAST VERSION 6 mt 4 mt Maximum length of bar 230Vac 24Vdc 230Vac... -
Page 3: Dimensions
DIMENSIONS FITTING AND HOUSING FOR ACCESSORIES Key selector Flashing + limit switch Photocell Control panel Backup battery 2x12V 7Ah only for BEV 2-24V Column... -
Page 4: Considerations For Installation
CONSIDERATIONS FOR INSTALLATION Ÿ The installation and testing operations must be performed by qualified personnel in order to guarantee the proper and safe operation of the automatic gate. Ÿ The company declines any responsibility for damage caused by incorrect installations due to incompetence and/or negligence. INSTALLATION Set up an electrical multi-duct conduit in the middle of the foundation of the barrier, corresponding to the central hole (corrugated - diameter 25 - 50mm). - Page 5 SHAFT SUPPORT Shaft Screw Insert the bar support on the shaft and fasten it with screws Insert the bar in the support and tighten the screws Screw Screw OPENING DIRECTION Bar support To change the direction of opening from the left (standard) to the right proceed as follows: Ÿ...
- Page 6 Holes B Ÿ Replace the trapezoidal Position B Position B bracket and tighten the screws Ÿ Hook the spring in the opposite position (holes B) Trapezoidal bracket Trapezoidal bracket SPRING REGULATION Ÿ Release the operator Ÿ Acting on the lower tie nut, put the Spring adjustment spring in tension until the rod is holes.
-
Page 7: Troubleshooting
TROUBLESHOOTING SOLUTION PROBLEM PROBABLE CAUSE 230 volt mains voltage Check master switch absent Check for any STOP selectors or commands. Emergency STOP If not used, check jump- present On giving a command er on STOP contact in- with the remote put on the control board control or with the Replace with one of... -
Page 8: Safety Precautions
Failure to adhere to the above indications may be dangerous. The data and images are for guidance only VDS reserves the right to change at any time characteristics of the products described in its sole discretion, without notice. Via Circolare p.i.p. N° 10 65010 Santa Teresa di Spoltore (PE) - ITALY Tel.