APPLIED ELECTRONICS ERGOADVANTAGE 7823H Series Quick Start Manual

Avia Pole-mount Monitor Arm
Assembly Instructions
Page 1 of 3
7823H & 7818H Series
1. Mount pole (F) to work surface using either the clamp
or grommet (see sidebar).
2. Assemble support ring (D). to pole at desired height.
3. Mount arm assembly (E) or dual hub with arms (m)
to pole (set to correct height) and tighten set screw (G)
to for correct tension, followed by trim ring (A).
4. For additional screens, repeat steps 2 to 5.
5. Insert monitor cables through cable managers (M)
and support ring tabs (D).
6. Mount monitor onto knuckle (C).
Dual Hub Models
1. Mount pole (F) to work surface using either the clamp
or grommet (see sidebar).
2. Assemble support ring (q). to pole at desired height.
3. Mount Dual Hub assembly (n) to pole (set to correct
height) making sure the front plate slides between
the cable managers on the support ring (q) followed
by trim ring (A).
4. Tighten set screws at rear of hub.
5. For optional third screen, assemble support ring (D)
to pole at desired height. Mount monitor assembly (C)
to pole (set to correct height) followed by trim ring (A).
6. For additional screens, repeat steps 2 to 5.*
7. Insert monitor cables through cable managers (M)
and support ring tabs (D) and/or dual hub support ring (q).
8. Mount monitor onto knuckle (C).
*20 lb. maximum screen weight per monitor mount.
m
C
M
n
M
C
Your arm style
may vary from
illustration.
A
D
B
F
A
q
B
C
F