Table of Contents
Advertisement
Quick Links
INSTALLATION MANUAL AIR CONDITIONER
TYPE : WALL MOUNTED
Original instruction
SAFETY INSTRUCTIONS
The following safety guidelines are intended to prevent
unforeseen risks or damage from unsafe or incorrect operation of
the appliance. The guidelines are separated into 'WARNING' and
'CAUTION' as described below.
!
This symbol is displayed to indicate matters and
operations that can cause risk. Read the part with this
symbol carefully and follow the instructions in order to
avoid risk.
WARNING
!
This indicates that the failure to follow the instructions can
cause serious injury or death.
CAUTION
!
This indicates that the failure to follow the instructions can
cause the minor injury or damage to the product.
The following symbols are displayed on indoor and outdoor
units. (for R32)
Copyright © 2016 - 2021 LG Electronics Inc. All Rights Reserved.
1
ENGLISH
MFL67713839
Rev.04_032321
2
Advertisement
Table of Contents
Related Manuals for LG AM07BP.NSJ
Summary of Contents for LG AM07BP.NSJ
- Page 1 ENGLISH INSTALLATION MANUAL AIR CONDITIONER Copyright © 2016 - 2021 LG Electronics Inc. All Rights Reserved. TYPE : WALL MOUNTED Original instruction MFL67713839 Rev.04_032321 SAFETY INSTRUCTIONS The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance.
- Page 2 • Do not use copper pipes which are deformed. Otherwise, the expansion valve or capillary tube may become blocked with contaminants. • Ducts connected to an appliance shall not contain an ignition source. • The installation of pipe-work shall be kept to a minimum. •...
-
Page 3: Installation Map
INTRODUCTION INSTALLATION MAP Features Air filter Installation plate Front grille Sleeve Signal receiver Bushing-Sleeve Display Putty(Gum Type Sealant) Bend the pipe as closely On/Off button Air outlet on the wall as possible, but be careful that it Air deflector doesn't break. Plasmaster Ionizer (Vertical louver &... -
Page 4: Fixing Installation Plate
Fixing Installation Plate Drill a Hole in the Wall Pull back the tubing holder. Good case Remove pipe port cover and positioning - Press on the tubing cover and unfold the The wall you select should be strong and solid - Drill the piping hole with a ø65mm hole core the tubing tubing to downward slowly. -
Page 5: Connecting The Cables
Connecting the Cables NOTE Connecting the installation pipe Wrap the insulation material and drain hose to the indoor unit. around the connecting portion. The power cord connected to unit should Indoor unit be selected according to the following Align the center of the pipes and sufficient- Overlap the connection pipe insulation national wiring regulations. -
Page 6: Checking The Drainage
NOTE Checking the Drainage Finishing the indoor unit Seal a small opening around the pipings Be sure to use a manifold valve for air purg- installation with gum type sealant. ing. If it is not available, use a stop valve for To check the drainage. -
Page 7: Test Running
If the actual pressure are lower than to 57. shown, the system is most likely under- Click the “Receive” button on the main screen of LG AC Smart Diagnosis App on charged, and charge should be added. NOTE your smart phone. -
Page 8: Tips For Saving Energy
Install the outdoor unit on the opposite side of the sea wind direction. - If you can’t meet above guide line in the seaside installation, please contact LG Electronics for the additional anticorrosion treatment. Push down hooks to assemble the air filter.