Advertisement
It will be necessary to drill a 5mm hole in the car body behind the license
plate. Insert the connection cable of the rear view camera through the 5mm
hole. Connect the plug of the camera cable to the plug of the video/power
cable inside the car.
Note: Before drilling the hole for the camera cable into your car make sure
that it is the middle of the car. The camera can display with its 160° viewing
angle the most area behind your car.
Install the rearview camera
First check areas behind the car body to see if it is clear to drill
rearview camera use two screws to fasten it to the car body above/beneath
the license plate next to the 5mm hole.
Note: Before fasten the camera make sure the camera image in the mirror
display is not upside down. If the camera image is upside down it is
necessary to turn the camera holder by180° degree and screw it back on.
Mirror setting menu
Important: Before you can make changes to any options make sure the
device is not recording. Only when the device is not recording you are able to
make changes.
The functions of the mirror menu are listed below. Long press the menu
button to enter the menu. Navigate through it by using the up, down and OK
button. To get back to the live image press menu button
Resolution
Quality
Loop recording
Choose between FHD and HD resolution.
FHD resolution is interpolated.
Choose between the quality 1MP, 2MP, 5MP or
8MP for the video record.
2MP and 8MP are interpolated
When the MicroSD card storage is full the oldest
file will be deleted.
Here you can choose between Off, 1Min, 2Min,
3Min.
The minutes are the time of the recording length.
By default the recordings are 2 minutes and every
2 minutes a new video is started.
.
To install the
Advertisement
